Expressway-C/E pair version X8.5.2 cannot locate CMR-Cloud using SIP protocol but correctly locates it via H.323.Anyways, call goes through in SIP. Anyone with same issue?Thanks. --Filippo
Hi, A really quick one... I have a SX80 deployed at a remote location and we've had a few instances where the device has been inadvertently disconnected from the power. When the power is returned, the device does not return to operation without som...
I have an employee who has started receiving several calls a day from a "Blocked Number." The person on the other end of the phone never speaks; if my employee doesn't speak, the caller hangs up. When I search in CDR (CUCM 9.1), the Calling No. and...
We have our branch locations set at the default 384kbps for video calls between branches. Intra-office calls can use unlimited bandwidth. The problem is, unless I hard-set the phone to a bandwidth under 384, the video call fails. Even when set to ...
I've configured my VCS and CUCM as per the deployment guide: http://www.cisco.com/en/US/docs/telepresence/infrastructure/vcs/config_guide/X8-1/Cisco-VCS-SIP-Trunk-to-Unified-CM-Deployment-Guide-CUCM-8-9-and-X8-1.pdf It's been working fine for a coupl...
Hi, I have a telepresence system with Cisco VCS, MCU 5320, and some P65" dual profiles, my issue is when P65 dual is in bridged conference through MCU it receives presentation on main screen not on presentation screen. In point to point call there is...
Dear team,We have CUCM 10.5, VCS Control, MCU, ISDN GW TMS Infrastructure deployed in one of our customer place. Now Customer asking us for Internet endpoints to be able to join CUCM registered endpoints. But we have got Expressway Edge licenses and ...
Hi Team,I Have C20 & System is working fine. My Question is here that i want to record video conference session so can you guide to me that IPVCR is perfact or not for recording the VC session. I know that IPVCR end of sale but we have purchased last...
Client has UCM v 9.2. and recently purchased additional TP room licenses. Unfortunately they were Telepresence 10.x (LIC-TP-10X-ROOM) and not the proper 9.x of the UCM. How can these be converted?
Hi ,Recently i had to change the switches to 3850 from (3650 x ) . Now all the video shows on the tv is distorted Any Qos need to be added on the switch Thanks
Hello. I have VCS Expressway X8.1.1 that sends some of the calls through specific tunnel (and not over the internet which is a default). For these calls route is upc_FW_Traversal -> Zone001ToTraversalSZ -> TraversalSubZone -> Zone006ToTraversalSZ -> ...
I deployed the Expressway C&E for the VPN-less Jabber, that is working.Unfortunately, I deleted the "Network Adapter 3" of Expressway-E on vShpere. Now, the Expressway-E happened the hardware failure.Exp-E LAN-1 should be the internal network and LAN...
Hi All,I am trying to change the provisioning mode to TMSPE and have succesfully installed TMSPE 1.0 on TMS Appliance version 13.2.1.Now I am trying to use the migration-tool to migrate all of the existing settings to TMSPE, however, I am getting the...
We got three offices who bought SX20 ( 4 of them ). Video/Audio works great while the problem happens with presentations. When somebody is sharing their desktop we can all see it for 30 minutes. After 30 minutes everybody looses the desktop share and...
