TelePresence and Video Infrastructure

Hi Teamcan we used the CTS-CTRL-DV10=  at cisco end point SX20 or C series ?  ThanksYusuf

Hi,I am a Cisco Certified Instructor (22845) and I am preparing the CCNACollab.There is a web CVND1 course that costs about 400 $ . Is it possible to attend it (or someway accessing the same info) free of charge or at least at a lower price?Thankful ...

Codec cannot reconcile ande establish video with remote site trough ISDN Gateway. But my videophone can. Where is configuration mistake?In attach two debugs from ISDN gateway:1.txt - sx20 call2.txt - cisco videophone call

By default, single conferences start on the left screen.  The customer would like to change it to the right.Units are registered to CUCM 10.5.

Hello,I have been tasked with setting up a Tandberg VCS to accept both internal and external calls.  I was able to set it up to accept the internal calls, but I have had no luck setting it up for external.  Do I need a second VCS to be able to do thi...

I am having trouble finding information on exactly where the wall outlets for power and data should be located when preparing a room to install a wall mounted MX800.  I see photos of an installed system online and it looks clean, so the power and dat...

Hi,I'm designing a cheap method to make the recording on Cisco VC point to point call.Cisco SX20 (HDMI-output-1) ------ HDMI splitter -----(separate two HDMI output) ------ Monitor ===== Video Recording Server / Hardware(I must restrict to record the...

Hi,ExpertsHave you ever test the situation that standalone SX10 ip dialing to polycom MCU RMX500？is it possible（no vcs or cucm）