TelePresence and Video Infrastructure

I am curious if Cisco has any plans or options to improve the quality of the presentation sharing on the CTS endpoints.  Currently, when sharing on the CTS’s, the presentation seems to pixilate (blurry refresh)  every 15 to 30 seconds even when there...

I am trying to run auto qos on a 6509-E but the option isn't there. I have tried enabling mls qos from global config, but the auto qos under interface config mode still doesn't show up. Any ideas? We need to use auto qos as a temporary measure. Thank...

Has TMS 14.1.1 been submitted for JITC certification? If so, when can we expect it to be certified? If not, when can we expect submission?Sent from Cisco Technical Support iPhone App

Could you please let me know what statement below is correct for VCS Clustering (or possibly both are incorrect?).Is Example 1 or 2 correct with regards to the License Keys. (The keys are examples)VCS – Master (Example 1)H.323-SIP Internetworking Gat...

Good Evening,The IP Phones do not get their respective IP addresses from the DHCP pool, however the PC hosts managaes to get their IP addresses from the Data pool. I have written the entire configuration out for you. I have tried all kinds of variati...

CUCM 9.0 and TX6.  I was able to register and boot a codec and a Touch 12 hours ago.  Then I am staging another pair of codec and Touch 12.  Codec booted and registered ok with CUCM.  Then I plugged in the codec and right around step 5, the image sho...

How?thanks           

Hi,After Upgrade C20 Codec to TC6.0.0 the system now keep staying in Maintenance Mode. Reboot and Reset on codec did not resolved the Issue. If a CISCO Technician need current_logs_bundle for analysis, i can send it across by mail.

I have two SX20 codecs I am controlling through the USB port on the back of the codec. This communication will stop working over time. The only way to re-establish communication that I have found is to either hard reboot the SX20, or unplug the USB c...

My organization has a couple E20's and are still running CUCM 7.1.5.33900-10.  Has anyone successfully registered an E20 in this version of CUCM?  If so, need some guidance.  Thanks!