TelePresence and Video Infrastructure

I'm attempting to customize my TMS email templates (specifically the 'Edit Booking Confirm" template using plain text). When particpants receive their Booking Confirm email one section reads: "The participants will connect using this route". Under th...

Curent setup C40 codec (multiway enabled) VCS 7.1 Conference Factroy configured MCU4510 ad-hoc template configured. This is all working correctly.ScenarioC40 using multiway adds 3 additional particiapants to the conference. When the C40 (Host) leaves...

Hi, We have a situation today someone tried to call internal endpoint- xxxxx (h.323) from public Internet by using below string.Xxxxx@vcse.company.com.au.Where VCSE.company.com.au is the A record for the VCS expressway and public DNS server ha...

Hi,I am using CUCM 8.6.2a to get CTS 500-32 (SW Version 1.8) register. Installed the COP file and touch panel is up. I am able to make calls from a CTS 500(SW Version 1.6.8)(IP Phone SW Version 9-2-1)  or CTS 3010(SW Version 1.6.8)( IP Phone SW Versi...

HiIs it possible to integrate the TMS solution into Office 365 for planing a Meeting.TaxSent from Cisco Technical Support iPad App

Hi Folks,I need to demonstrate the functionality of TMS integrated with TMSXE to a Customer. Could anyone tell me , how can I go about doing it?I have already installed TMS 13.1.2 on my VMware Workstation 8.0. I need to integrate TMS with TMSXE so th...

Has anyone had any experience implementing QoS with the output of the Telepresence Content Server?  I want to mark the packets for multicast output specifically.  I reallize there are multiple ways to do this, but I was wondering if anyone has had an...

Hi all,In CUCM serviceabilty>Tools>Featured Services, i found the page was blank. (attached)is it normal ? because when i read the manual of CUCM 8.6, for adding the Tandberg Endpoint TC5 to CUCM, there is need to activate in that page.please help

Hello all,We have a VCS, and MCU4500 with 12 media port lic.  All the Tandeberg endpoints EX90, Profile 52 etc..registered with VCS using h323&SIP.We have an existing CUCM 7.0 with 99XX series phones.I know we could integrate both CUCM and VCS using ...

Hello Community,How do you integrate CTSs and WebEx?I look forward to your helpful information.Regards,

HelloI am trying to add CUCM to TMS.  CUCM is sitting in DMZ.  TMS is stting on the internal network.I am getting a system status error:No HTTPS response.I have done all the needful in CUCM i.e adding app user, user group and appling permission.Could...

hi all,im wondering on C40 integrator package as i have seen this option key :LIC-INTP-C40-DD --------> Integrator Package C40 Dual Display Optionis that really necessary required when you only have oen monitor ?what is the use of that option above !...