Unified Computing System Discussions

Just received our new hardware to replace almost everything in our data center. 4 new ESXi hosts and 2 N9K-C93180YC-FX3 switches.I’m new to the 9k series. In our old setup we had 2 nexus 3k (L2 functionality only) redundant links to each ESXi host an...

We have 3 C220 M4 units and I have a problem with one of them.Simply, it has no video out.The monitor stays off but will flicker to life each time the video changes mode. (several times during BIOS startup)Video works fine on the other 2 units, so ca...

It's been a number of years since I have had ownership of a UCS environment. Currently, I'm going through and cleaning up some odds and ends that seem to get missed when care and feeding aren't being done. Long story short, I had to create a new boot...

Hi folks,I am trying to get the inventory details containing rack and blade servers information from Cisco UCS using the REST API endpoint /nuova. For getting the blade servers, I can use classId=computeBlade and for rack servers, I can use classId=c...

All, We have deployed many VMware vSphere / vSAN clusters over the years on UCS M5 and M6 hardware.  In those cases, the Cisco HBAs were always on the VMware vSAN HCL.  In the case of the UCS M7 series, the only HBA available is the UCSC-SAS-T-D, and...

Can Intersight CVA be configured for high availability?

We have a HyperFlex Edge cluster with 2 nodes. We don't use HyperFlex Edge nor do we manage the nodes via Intersight. Interestingly enough, the HyperFlex web portal for our hosts shows it is tied to an account. We do utilize these hosts for our Cisco...

This morning, we are seeing that UCS cluster IP is not accessable over HTTP but it was pinging also we are not able to do SSH to any of the IP address(2 FIs or cluster IP)

  Hello, Our customer has UCS 6332 in a cluster. We would like to know if it is possible to Connect HA FortiGates directly to Cisco UCS 6332 using LACP Aggregate interfaces and Virtual Port Channels (vPCs)(full mech)? Thank You

Hello,i recently got my hands on a Tesla P40 GPU that I would like to use in my C460 M4.The power connector has caused me a lot of confusion.as I understand it, the Tesla P40 makes use of a 12V EPS connector.the connector on the PCIe riser board also...

Hi there, I have been doing an extensive search regarding the compatibility of Cisco B-series servers with Nutanix, and I've found that it used to be compatible with B-Series M4 only, but now it's reached its EOL (https://portal.nutanix.com/page/docu...

Hi All, We keep getting the error detailed attached when trying to install ESXi 7.0.3 on Cisco UCS C220M7N even after upgrading the latter one to the most recent CIMC version 4.3(3.240043) using ucs-c220m7-huu-4.3.3.240043.iso. Has anyone seen the sa...

Im a bit at a loss. I have and older ucs system with b200 m5 blades. I am reusing those blades in a whole new environment due to hardware refresh. The new environment is managed via IMM only and there is no UCSM.When i go to deploy my newly created S...