Voice Systems and Accessories - Small Business

I have some problem with my SPA-504G, the ip phone don´t sent a DHCP discover on the voice vlan, this works fine if i dont enable the vlan taggin and unset te vlan, when i set this parameters the phonenot receive ip automatically, but if i set the ip...

Hi All, I have a setup with CUCM, CUC and CCX are configured in Business Edition 6000. I want to setup Auto Attendant with the below requirements. All incoming calls from PSTN network (configured in Cisco 2921 gw) will land to Auto Attendant Extensio...

Hi all,I have a SPA-921 that suddenly stopped working.When its connected either on the PoE interface or directly to power source, LEDs are blinking in the following pattern:1) mute, headphones and speaker light on, then2) headphones and speaker off, ...

It seems that every line (extension) has own dial plan.Anyway to pick the right line depends on dialed number?For example, I have two totally separated PBX. One has internal numbers starts from "1" and another starts from "2". They are assigned to tw...

Hello,  I have a Linksys SPA921 Ip phone and it will sudenltly not power on.While i connect it with, either PoE or Power Supply, it blinks at the following pattern1 ALL (Microphone, Headset, Speaker)2 Just the microphone3 Speaker and Headsetwithin tw...

Good morning everyone!I'm from Brazil and I currently having many problems to provide a solution for my University's Final Project.Currently I have the following:Softphone/Analog Phone <<< >>> Asterisk <<< >>> SPA3000 <<< >>> PSTN line.I configured a...

Does the SPA122 ATA have an on-board TFTP server?The documentation implies that it does.Page 32 of the Administration Guide describes configuration of theon-board DHCP server, particularly when the value "NONE" is selectedfor the Option 66 parameter:...

Hello,Trying to reload a Cisco UC 520, CUE, only, the CF card went bad, I replaced it.There were no backupsUsing cli, I did a service-module integrated-Service-Engine 0/0 reload and confirm, then service-module integrated-Service-Engine 0/0 sessionco...

Hello, I am wanting to change the 7905's I have over to SIP... I have set up the TFTP server with the appropriate files: CP7905010100SIP030807A.sbinCP7905010100SIP030807A.zuplddefault  (cfg file) The TFTP Server Log shows as follows:Connection receiv...

Hello !Cisco announced that the spa122 replaced the spa3102 but this one has no FXO port !I would like to block/filter specific incoming PSTN calls by using an asterisk server. Spa3102 was the right product (by connecting the line port to an adsl spl...

Hi,I'   I'm in the middle of a BE6000S quote in CCW and I don't see any reference regarding paging capabilities for users. Does the BE6KS page server support the same 50 IP phones as the BE6K?    TThanks   

Hi,obviously the switching between bridge and NAT mode, using the IVR code 201# still isn't working in the latest firmware.201 lets you chose between NAT (0) and bridge (1) for the yellow ethernet port - at least on the SPA-2102 and SPA-3102.The SPA1...

When I click on Message button >> Enter your Pin press # >> After entering Pin # >> press 6 to Forward  >>(After pressing 6) Record your introduction and press # >> Spell last and First name >> Press ## to change between Spelling and Number entry >> ...