Voice Systems and Accessories - Small Business

We have 2x SPA122.Both are connected to a CE500 switch where the voice voice VLAN is set to vid 6 and CDP is enabled.The first SPA122 is configured to enable CDP and DHCP successfully allocates it a lease in our vlan 6 subnet.The second SPA122 is con...

I have recently set up one SPA302D handset and SPA232D ATA to use as a voip phone in a separate area of our business. The incoming calls work fine but we are unable to dial out. The internet/voip service provider has told us that everything is fine w...

I have a Spa3012. When trying to activate the IVR with ****, the Spa3012 tries to connect to an outside line.  Any suggestions?

Can the UC560 be setup to use IP based authentication instead of SIP authentication for flowroute?

Hello. I have a linksys ip phone spa941. Dhcp is enabled and the phone has received ip address. I can't configure it by web interface. Can you help me to solve this problem

I have a BroadSoft system with SPA508 phones . Some phones show domain name as part of the caller id ex: 2010@abc.com,  so when i try to dial a missed call it sounds busy because it tries to dial 2010@abc.com instead of 2010.Not all the phones in the...

Hi,I have 3 analog lines coming into UC540.  Been working fine for three years.I had been using AutoAttendant but the client just added a receptionist so I have sent the lines to her extension.  Line one incoming sometimes rings once at her extension...

We have old PSTN analog cable used for PABX, and we want to connect it to Cisco Voice Gateway , it can be connected via FXO card but the problem is we used 10 analog lines for getting simultaneously calls, is it possible to be solved via FXO cards? o...

UC320W v 2.2.2(1)Recently switched from SIP provider to local cable provider using phone line adapters with 4 FXO ports into the UC320.When i call into the UC320 externally i see the following in the external call records logTimestamp: Trunk: Directi...

So I have a bunch of these deployed, and they're starting to make me go insane. Just lots of little problems that never go away. Heres the scenario;1 SPA232D Base3 SPA302D Handsets2 Registered DECT lines (Same number)---------------------------------...

Hello,What recomendataions do people have when it comes to headsets for the SPA series?Ideally we would like them that connect to the headphone jack on the phone.

We have a customer with an outdoor viking door intercom connected to the FXS port of the UC320.It has been intermittently working -- works one day, then not the next.They report that when the button is pushed they get a red light and silence (versus ...

        Hi,             We are having UC560 in our company. suddenly our cue has stopped working.unable to reach cue..its giving fast busy tone but in CUE "service-module integrated-Service-Engine 0/0 status".. everything is up.when i am trying acces...