Voice Systems and Accessories - Small Business

Hello,I'm configuring several Linksys VOIP (SPA922 and PAP2t). I use the provisioning feature to allow downloading the configuration from a central TFTP server.Currently, I added DHCP option 66 to pass TFTP server to phones. Since phones share the sa...

Cisco UC520 trying to bind a specific IP to a host, here's the config snip:ip dhcp relay information trust-allip dhcp excluded-address 10.1.1.241 10.1.1.255ip dhcp excluded-address 192.168.10.241 192.168.10.255ip dhcp excluded-address 10.1.1.1 10.1.1...

UC520 is connected to a sip provider which has some star codes that I want to use, but they start with two stars.They enable dialing SIP URIs, for example, **275 connects me to www.sipbroker.com from which I can dial SIP destinations wihtout using PS...

I have a client that has a UC520. they have been having issues off and on but they are now experiencing "max phones" issue when they have some of their people login to Extension Mobility. The config shows max-ephone 32. any suggestions?              ...

I have some problem to set the password and the time server with the SPA112.Does anybody knows how to set them in the in the .xml file.My Example is:     <!-- Time SetUp-->             <Time_Setup>             <Time_Zone>+01 2 2</Time_Zone>          ...

I have tested and verified my provisioning server is sending my SPA122 all of the specific value's that I want implemented on my lab unit. When we deployed a unit into production, using the same provisioning server it's missing a bunch of specific XM...

So I got the UC540 today and have it all set up, was very easy thought it would be worse.  All is working fine, SIP trunks etc, have a few minor things to play with but all is well so far.  I just can't figure out how to properly put 2 extensions on ...

hii have 4 SPA502g ip  phones connected to a UC320w i need to change DTMF Tx Volume for AVT packet: Default is 0.  i have a problem calling an external IVR how do i ?thanks in advanceregards

                   I have used the Config Wizard to set up the UC520 but I am having DNS issues when trying to gfet out to the internet. When I check the System Status it shows "None" under the Gateway column. Under Routing/Internet Connection/FastEt...

Hello,I need some help with the following problem Call Pickup or Directed Call Pickup gives One Way Audio on a SPA525G. It doesn't mater if you use *98 or *97 followed by the extension of the phone to pickup the call from another phone that is ringin...

Hi,I have a UC560 that's been installed by our telecomms partner - over the course of the past 2 months I've been learning lots about the UC560 (even though I was a Cisco virgin prior to this!) and it's plentiful...quirks shall we say!At the minute w...

Hi,I have a Cisco SPA112 which connects to a 3CX server. I also have addional phones, inluding Cisco SPA504G phones.The issue I have is the SPA112 reboots every 3 days, exactly to the minute. This has happened 3 times now. The 504G is fine (40+ days ...