Voice Systems and Accessories - Small Business

I can't get the system status to work in CCA 2.1I obtain my IP info from Verizon.  The subnet is 255.255.255.255.The error I get is a subnet mask can have 1-31 bits.Bit specified 32.I have no control over that, I get my info from Verizon.How can I fi...

Is there a way to add a 2 second pause between numbers when adding a speed dial to a phone in CUE?

Hello,we have a 3102 set up as an ATA device only for an Analog Phone (the PSTN port is not used). The 3102 is connected to a software IP PBX. Onbound/outbound calls are working fine, we just have an issue with the caller ID displaying on one particu...

Dear ALLPlease let me know where I can take SPC utility (Windows/Linus)  for SPA3000 fw spa3000-3-1-20GWThank's in advance.

I am trying to plug a Linksys SFE2000P in the expansion port of a UC500 to add some extra phones to a system.  I preconfigured the phones directly connected to the UC500 before I moved them over to the Linksys.  I cannot get them to work while connec...

Line 1 has one IP phone service. Line 2 has Gizmo5. When I connect brother mfc845cw fax phone to line1 port. It can receive both line1 and line2 calls. When I connect this fax phone to line2 port, it only receive line2 call. The fax phone has 2-cord ...

Hi - I posted this earlier on Voxilla but no replies yet.When I have dialled a voip call or pstn call that is busy/engaged I want to instruct SPA3102 to keep trying to redial the busy/engaged number until it rings, then to ring my FXS connected telep...

Hi,We have a bunch of SPA9x phones from an old project and I was wondering what I need to do to get them to work with the UC520?Thanks in advance,Bob

What are the recommended analog phones for UC520 platform? Will the analog phones continue to work when the UC power goes off?Hanu

Quick question?I'm generating reports in cisco historical reports client. They appear to be in a different time zone, 6 hours ahead. I have checked the time zone on the uc520 and it's setup for the correct time. The ntp server is pointing to itself @...

Considering deployment of a UC520/540 for a smaller site.   The customer likes the option of 'mobile voice access' in CUCM 7 where remote workers can dial into the office and place outbound calls via their office line.Does an option or product exist ...

We have a client interested in the SBCS, but all the computers in their office are Macs.  I'm wanting to know if there are ways to run software such as IP Communicator and Unified CallConnector other than a virtual Windows machine through parallels.A...

Is there a way to reset the watching ability of system?   Since new phones were installed and the old phones are now disconnected and deleted, it seems most of the phones that were watching the old phones are still watching the old phones, so the lig...