Voice Systems and Accessories - Small Business

Hi Guys,I have some issues with 521 and 524 phones (besides the microphone volume problem mentioned here: https://www.myciscocommunity.com/thread/2506?start=15&tstart=0)- The indication of missed calls in the staus line disappears after about 10 seco...

Could someone please direct me to some documents showing how to enable and configure extension mobility where multiple users can log into one phone have their separate profiles?

Hello everyone,I have a .wav file that I converted into a .au file using Audacity.  It has been sampled at 8000Hz and in mono mode and then exported as a ulaw .au file.The file sounds like it has been drastically slowed down.  I have messed around a ...

HiI was wondering if there is any recent bug free software pack and ios version that has been released after the 12.4(22) YB4 which i can use for a new install.Also which was the last most stable version of ios and software pack that i can use for a ...

I can't get the system status to work in CCA 2.1I obtain my IP info from Verizon.  The subnet is 255.255.255.255.The error I get is a subnet mask can have 1-31 bits.Bit specified 32.I have no control over that, I get my info from Verizon.How can I fi...

Is there a way to add a 2 second pause between numbers when adding a speed dial to a phone in CUE?

Hello,we have a 3102 set up as an ATA device only for an Analog Phone (the PSTN port is not used). The 3102 is connected to a software IP PBX. Onbound/outbound calls are working fine, we just have an issue with the caller ID displaying on one particu...

Dear ALLPlease let me know where I can take SPC utility (Windows/Linus)  for SPA3000 fw spa3000-3-1-20GWThank's in advance.

I am trying to plug a Linksys SFE2000P in the expansion port of a UC500 to add some extra phones to a system.  I preconfigured the phones directly connected to the UC500 before I moved them over to the Linksys.  I cannot get them to work while connec...

Line 1 has one IP phone service. Line 2 has Gizmo5. When I connect brother mfc845cw fax phone to line1 port. It can receive both line1 and line2 calls. When I connect this fax phone to line2 port, it only receive line2 call. The fax phone has 2-cord ...

Hi - I posted this earlier on Voxilla but no replies yet.When I have dialled a voip call or pstn call that is busy/engaged I want to instruct SPA3102 to keep trying to redial the busy/engaged number until it rings, then to ring my FXS connected telep...

Hi,We have a bunch of SPA9x phones from an old project and I was wondering what I need to do to get them to work with the UC520?Thanks in advance,Bob

What are the recommended analog phones for UC520 platform? Will the analog phones continue to work when the UC power goes off?Hanu

Quick question?I'm generating reports in cisco historical reports client. They appear to be in a different time zone, 6 hours ahead. I have checked the time zone on the uc520 and it's setup for the correct time. The ntp server is pointing to itself @...