VPN

We have been using MS VPN client to access PIX 515 VPN for one year. It works. The only problem is when the VPN client establishes the VPN, it can't access the Internet until disconnecting the VPN. I believe that we can configure PIX to point the Int...

We have the following ACL assigned to WAN port of our Cisco 831:access-list 111 permit tcp any any establishedaccess-list 111 permit tcp host [*remote private ip snipped*] any eq telnetaccess-list 111 permit esp any anyaccess-list 111 permit ahp any ...

What is the difference between VMS server and VMS client?

Hi,Can someone help me out with the best way to secure an extranet VPN.Its basically to give 3rd party companies access to support and troubleshoot some of our systems.I can envisage two VPN scenarios:Company A who has a VPN gateway so a static site ...

I just installed a HWIC-CABLE-D2 in a 2811 router and connected it to Comcast's nework. The connection works.However the show controllers cable-modem command tells me it is operating in DOCSIS 1.0 mode. How do i get it to operate in DOCSIS 2.0 mode...

I have a cisco 1841 router and i want to use web vpn on it i mean ssl vpn which ios is needed for ssl vpn as well as plz tell me the ssl vpn licence cost . I have heard that 2 SSL VPN Client Licence are free on but SDM doesnt allow me to do that

Hi,I have setup a VPN tunnel between a 515E & an 857 router. The tunnel is established via the internet and hosts on both ends can ping each other. The 515E is the hub device. All sites connect to this firewall. The 857 router is placed at a remote s...

Dear Group,I am currently working on L2TPv3 which provides layer 2 VPN and transparently forwards any layer 2 frames from one site of customer to other site over Service Provider's IP network. I want to know that which protocol provides stronger secu...

We have got a VPN 3000 Concentrator at work , what are the steps should be done to enhance the security for this VPN apart from SecurityID Token ?Regards

Dear Group,I am currently working on L2TPv3 which provides layer 2 VPN and transparently forwards any layer 2 frames from one site of customer to other site over Service Provider's IP network. I want to know that which protocol provides stronger secu...

Have a 2800 router configuring Dialin with the NM-8AM Analog Modem Module. Have the remote modem (US Robotics Courier) conencted to the router but don't seem to seeing any PPP packets or LCAP. config below and debug ouput. Why is the modem hanging up...

i am getting the following error , in the cisco 877 ADSL router connecetd to the internet adsl line .Can any one tell me if my configuration is correct ? and why this authentication error occurs ?Thanks in advance..i am also attaching my config !!...

Hello; I have configure the VPN on a router which contains two interface ATM, but the probleme it is that I cannot attenidre the seconde be cause i have configure an IP ROUTE 0.0.0.0 0.0.0.0 Dialer 0 I know not how how to share the load (c-?-d the ha...

I would like to create a site vpn between 2 871's using ctcp. Is this possible and is there a configuration example of how to do this. I can configure ctcp but neither end will initiate the session using ctcp. They use udp instead.