Wireless

Hi, we've faced very poor signal (50 cm to AP I get -40 dBm, if I go 10m further I got -60 dBm. 1 brick wall - I got -75 dBm although AP is about 3-4 meters away) with 1832I access points. Does anyone experienced this issue?Firmware version is 8.4. U...

Hi, I need help with the design for multi-tenant wlan solution. The tenants will be sharing the LAN, WLAN & IPVoice network devices.

buenos dias, Actualmente una sede de la red que administro a nivel de conexion inalambrica esta presentando fallas, los usuarios me indican que en un espacio entre 2 horas la conexion a la red no se establece de manera rapida y siempre falla. Pasado ...

Hello. I recovered about 20 Cisco Ap Wap2000.We used them for a structure but many clients complain about connection problems.I wonder: being old now (obsolete?) , they only support B and G, is it possible that there are many problems with wireless d...

I have problems with a WLC 8510 in which on the front I get a message on the screen of 6: D, currently I have it operating in HA but not working properly and I think it could be by this error. You have any idea according to your experience of that me...

WLC 5508 ISE - When using single SSID for BYOD from iPhone versions 12.x and onwards you need to apply config network web-auth captive-bypass enable on all your WLC's in order for the iPhone browser to be supported so supresses. That's a problem for ...

Hi all, You may not be able to give a definitive answer on this but my question is about the following vulnerability announcement:https://tools.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-20190417-wlc-iapp We're running version 8...

Hello all,I have 3 APs (AIR-CAP3702E-E-K9) in 3 building connected with each other and i want to run VoIP services within buildings , so my question dose it support or it depends on the Switches(VoIP service support)? Regards

I have upgrade Cisco WLC code. Code has been upgraded Successfully but aps are joining yet. From the logs i can see the following.Failed to authorize AP Name HAM03313AP12 with Base Radio MAC 00:2c:c8:82:93:c0. Authorization entry does not exist in AA...

I'm starting the path to CCNP Wireless. The test has recently been revamped and like a lot of new Cisco Certification tracks the test comes out before a decent amount of material. What would someone suggest to start this process while there is not a ...

Hi there, We have a complete Cisco Wireless setup. We need to implement BLE Beacons. what pre-requisites are required to implement BLE beacons. Thanks in advance. 

Hi, I was wondering if you have experienced adding a third-party WiFi Access Point to your Meraki network to extend WIFI coverage. If so, tell me your experience.Current Setup: MX64+MR33+Archer C7So far, MX64 manages the network as it act as a securi...

Hi All,I have a question I will implement WIFI at different country  just install APs (Flex) other country but center WLC(5520) install at my country afterthat i need APs will go to internet and join to my WLC center. anyone can have experience to di...

HiI am looking to advertise a number of wireless profiles for an organisation that has a presence on our campus.  I will use our APs to do this and then run Foreign/Anchor set up for each profile so that clients of these profiles break out onto the o...