Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Hi We have two controller flex 7510 and both are configured into HA with SSO. when i m checking the the log on the primary controller with command show logging last-reset i can see very few messages. and when i m using same command on the secondary...
Resolved! AP1552E can not register to wlc 5508
I have wlc type 5508 with version 8.3.102.0 and I am setting into a multi-domain, AP I use AP1572 type and status can join, but other types of access points here we use the type ap1552E status as a switch only join when I've upgraded to ios versio C1...
Resolved! Error in configuration of APs
Dear All, I am trying to configure controller based AP but not AP is not able to appearing on controller. Upon power on of AP it appears on controller for a second or two and then disappears with following message errors. Regards, Muhammad Noman
I have an AP where I intend to have 2 ssid where each one accesses a different vlan. On the switch side I already have the trunk made with access to these vlans.However I can only get network in the AP when I access the native vlan ... When I try to ...
Hello I have questions about HPE Clearpass. one of our Customer had HPE APs, Clearpass, HP Switch. but in further they want to change only Aruba APs to Cisco AP 2802 so my concern is if cisco controller or ME Mode are working okay with HPE ClearPass...
Dears, I have problem that our clients iphones(when its locked) keeps disconnecting from AP, is there any thing I have to do with my WLC(5500 series)? I have disabled the session timeout in my WLAN, bu still when I lock the phone and come again aft...
I have 3.1 prime and when I am adding 3802 working ap's to the maps, they are greyed out with a question mark. My wlc's are 5508's.
Resolved! Block inter-user traffic?
Hi, I remember there is a configuration on WLC for blocking the inter-user traffic (even users are on the same VLAN/SSID) but failed to find the feature in documentations. Anyone know the official name of the feature OR the configuration path to ena...
Hi ,is there any restrictions that 5760 Web interface will not work while it is integrated with ISE ?Thanks a lot !
Hello, Is there a command to change the mgig port speed for aironet 3800 (with mobility express)? I checked the CLI doc and do not see the command. Is there command similar to this: conf interface gi0 speed 100 duplex full end wr Thank you.
Hello, I configured a 1832i using Mobility Express, and added a second AP to this controller. Both are working fine, and the controller can be managed using the https GUI. However, both AP have also an "OfficeExtend Access Point" http interface. Bu...
Hi.......I'm using Cisco AIR-CAP 1700 series .My Router is blinking Red.I need help
Resolved! How many AP types CISCO have?
Hello all!! I have 1832 APs below I'm thinking how many ap type CISCO have. I think cisco ap type is 3. 1. controller-based like 1832 model 2. Standalone or autonomous 3. controller, not autonomous Is it right answer I think? Please check fell...
Hi, I have converted one 1231G into LAP mode and while trying to register same into Cisco WLC, after loading with LAP image (Recovery Image) it giving below mentioned message and getting again its getting rebooted. Also i have noticed that its not t...
Hi,I`m having some trouble to join the WLC.When i hookup the AP to a console cable the folowing message apears:*Jan 6 09:55:13.137: %CAPWAP-3-ERRORLOG: Certificate verification failed!*Jan 6 09:55:13.137: DTLS_CLIENT_ERROR: ../capwap/base_capwap/ca...
