Wireless

Hi, previously autonomous AP could set with Fixes IP. However, I see that the request for mobility express AP is having DHCP. Fixed IP is not for permanent deployment. May I confirmed this point from anyone of you? thank you

Guys, I have a client that receives the Net Virtua ADSL Link, with the following scenario:Link >> Modem >> TPLink >> Switch >> 5 Access Points. However, I need a CISCO solution for after the Modem, I insert an equipment to establish a Tunnel with the...

Wireless mobile client fails to connect in 2 WLANs (Corp and Guest) Corp is Radius authentication, Guest in WebAuth. Client was previously connected to both but after disconnecting, was not able to connect again.   From the device it is stuck in Conn...

Hi   I am trying to Power a Cisco 1562D wireless access point with a POE adapter. It works fine connected to a switch and I have found two recommended POE injectors AIR-PWRINJ-60RGD1 AIR-PWRINJ-60RGD2 Does anyone know of any indoor style adapters/inj...

Hi Cisco Team, Can you help me on to convert the Cisco 2702 to Autonomous mode. So far i already did some config on the AP. Pls see below : Light Weight to Autnomous CLI Commmands : -set ENABLE_BREAK yes-set IP_ADDR 192.168.0.1-set NETMASK 255.255.25...

Hi Experts,   I am new to WLC. Does vWLC supports High Availability with SSO? I am trying to configure but there's no such option. I'd like to clarify as well what is the purpose of virtual interface address?   Thank you for your support.    

Hello,   I have WLC 5520 to which already number of 2802i APs are registered. However, when I am trying to register a new AP it fails. I have noticed that it registers initially but then attempts to download software from the controller. Once the sof...

Hi,   We have a 8540 running 8.3.133 and around 3000 18xxi APs. Looking at some of our locations reporting poor performance, i see several of the APs on the same channel as eachother, or on the same channel as 3-4 rogues, at quite high RSSI (-60ish d...

Using 8510 with 8.0.121   Have 4 interface not working. When I ping the gateway this responds on the gui, but from CLI on wlc it doesn't. All the other interface are working correctly, just these for. I have removed them from Distribution and re-adde...

Hi guys, I am a beginner for network setup. I want to pair up all my aironet 2600 series together with connect a lan camera with each of the aironet.I want to set an access point as my parent then other ap connect to that access point. How do i set t...

is it possible to export the Device Data/Controllers/xxx/WLANs table? I need an SSID/interface/ACL report.. We are moving to NAC and reducing our SSID count to 2 or 3 instead of the existing 13 or 14. maybe I can shrink my APgroup count in the proces...

Hi all,   One of customers have 1142 AP model in their installation, they want to add AP1131, the WLC is running 7.0.116.0 version which is compatible with c1130-k9w8-mx.124-23c.JA2 version. How can I get that version? One of their APs is running it,...