Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Dear All,   I've got an existing remote management design over regular ISDN with dialer maps (One big L3 subnet, there's a separate ISDN call-number for each branch sites and in L2 we map the ISDN numbers with the IP addresses) The ISDN could in the ...

bebasa by Frequent Visitor
  • 947 Views
  • 0 replies
  • 0 Helpful votes

Hello,   I am looking to change the IP address range used by the management interfaces of the 7 WLCs in the organisation.  WLC1's Ip address currently responds to the CISCO-CAPWAP-CONTROLLER DNS Entry.   My questions are, when an access point communi...

Hi, I was looking through a packet capture for any signs of problem, to help me pin-point a problem with disconnects.   When looking through the capture i found a few occurrences of repeating cts's. Is this normal?

Hi guys,   I am trying to figure out what is causing my AP1852E to work only in Medium power. I have them connected to power injectors AIR-PWINJ6= which supports 802.3at but my wireless controller WLC-2504 shows poe status as PoE/Medium Power (15.4 W...

jsmoncayo by Visitor
  • 1347 Views
  • 4 replies
  • 0 Helpful votes

I have installed a Ubiquiti EdgeRouter X and a Cisco WAP361 Access Point. If I supply power to both systems at the same time, the Cisco AP only makes the 2.4G radio available. Some devices see the 5G radio, but cannot connect. If I then restart the C...

artstro by Community Member
  • 434 Views
  • 0 replies
  • 0 Helpful votes

Dear Team,   I just need to create one management vlan so I can assign ip to switches so can you please suggest how can we create management vlan in cisco 3750 its my core switch.

yogesh1 by Level 4
  • 917 Views
  • 3 replies
  • 0 Helpful votes

We are using WLC4400 and ACS4.0 with web-authentication. I'd like to know how to configure web-authentication user's session-timeout in ACS Radius server.We want to disconnect user's connection if user is not using wireless naetwork for some time.

yong1794 by Level 3
  • 825 Views
  • 1 replies
  • 0 Helpful votes

My customer is using WLC4400(4.0.179.11) and LAP1130(12.3jx1). Before converting IOS to LWAPP, the WLAN service is not problem.But after changing to LWAPP based,the customer is complain about disconnecting problem. Intel centrino and other vendor's w...

vivian4838 by Community Member
  • 913 Views
  • 2 replies
  • 0 Helpful votes

Hi,   Anyone have problems with WLC captive portal, after 1.1.1.1 Cloudflare dns have been launch? I have 1.1.1.1 as my virtual web portal, and after the relase from cloudflare 1.1.1.1 dns, my captive portal stop to redirect after accept disclaimer. ...

NelsonGuedes by Frequent Visitor
  • 3042 Views
  • 4 replies
  • 0 Helpful votes

Hi support,   Our customer has a configuration with AAA override but returning VLAN string instead of VLAN ID tag. For this scenario, everything is working fine in a centralized mode (WLC get VLAN string from RADIUS response and allocate users in the...

JPavonM by VIP Alumni
  • 1153 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card