Wireless

We have a test SSID setup with web authentication via Radius on a WLC5508.  Works great.  But the boss would like it to not require re-authenticating every time a student attaches to the SSID.  Is that possible using just the WLC5508, or do I need so...

We have Cisco 2504 Controllar with running version AIR-CT2500-K9-8-0-133-0 and all Ap's are on same platform.Suddenly one AP down after 12 hours or 1 hours,24 hours.Time is not fixed to down.In Log i am getting below messages:-- apfReceiveTask: Jul ...

Hello guys, I have a wireless environment, composed of the following equipment: - 25 Switches Cisco 2960G - iOS 12.2 (55) SE5 - 67 Access Point 3502E - 2 WLC 2500 - 50 Clients Supported - 68 CK3X Intermec Handhelds I have enough WAN bandwidth, my usa...

Failing to access cisco aironet 2600 CAP access point after upgrading to version 15.3. when i connect through wireless network it fails to access but when i connect my laptop on same network with LAN, it web access and all things are available. when ...

I have a 5508 series WLC running 8.0.135.0. I have noticed that the rogue APs do not show up in the GUI until you run #show rogue ap sum in the CLI. Then again to get an update you must run the CLI command. Has anyone noticed this?

Hi everyone! I have an issiue with my WLC, when I configure the interfaces and te AP´S for the firt time the will work well, but the problem is when I reset the WLC I can´t see the Access Point Anymore. Only if I reset the WLC I can see them again. C...

Hi all, What is the best way to debug clients which are disconnecting after about 5 minutes ?  I've got Management > Logs > Config > Msg Log Configuration to Debugging, but this doesn't seem to show clients connecting or disconnecting, and more impor...

Hello, I have a CMX 10.2 located in a DMZ for External splash screen for guest authentication at a remote location using a Cisco 5508 WLC. after we setup the CMX, the guest can authenticate just fine!!! but now any body can access the web based ma...

Will access points installed at a branch site (different subnet) automatically find our WLC 2504 at our headquarters over the WAN?  The sites are connected via MPLS.  Does CAPWAP automatically jump from one subnet to another over a routed network?

I'm looking at some Cisco WLC configs for a customer and under 2.4GHz settings, 11mb is Mandatory, and 5.5, 6, and 9 are set as Supported.  1 and 2 mbps are disabled.  There is no other Mandatory rate set on the band. Can anyone give me an example of...

I have a 5508 series WLC running 8.0.135.0. I have noticed that the rogue APs do not show up in the GUI until you run #show rogue ap sum in the CLI. Then again to get an update you must run the CLI command. Has anyone noticed this?

Hi all  just small Question about MSE version 10 if i buy it as a virtual can i installed in hyper V or not ? and what is the specification for that ? thanks 

I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?