Wireless

Hello all,I ‘have deployed CT 2504 and CAP 1600 wireless solution, and I'm facing issue with same wireless clients.I have this message error:"Decrypt errors occurred for client 00:23:xx:xx:xx:xx using WEP key on 802 interface of AP bc:xx:xx..."The Co...

Every 60-62 seconds I would see my signal drop out and association go away if I was watching the cisco client utility. I investiagated and found it to be an XP issue. XP's Wireless Zero Configuration service. It tries to look for an ap/better signal....

Hi,Just wondering whether Cisco has plan to support Wireless MAN(Metropolitan Area Network) in its product range?Thanks.Regards,Delon

We are putting a proposal together to purchase a WLSE, ACS, and a few APs, to start with. As a part of this proposal we need to obtain at least two references from individuals/organizations who have already successfully implemented this type of solut...

Can't do Audit and Refresh from Config and giving the Error: Access is denied.. See attached.

Hello,We would like to know the period of off-channel scanning while the AP is in local mode and WIPS sub-mode (ELM). Also how long does the AP scans each channelWe'd like to know if using ELM has any effect on the connected clients' traffic throughp...

Hello.Some days ago, I updated our 5508 WLC to software version 7.5.102.0.With that version, it should be possible to have a VLAN mapping specific for a Flexconnect group that is set within Flexconnect Group settings.I did that for all my Flexconnect...

HI, I am using WiSM-2s running 7.6.110.0 and Cisco Prime running 2.1. I have a daily report setup to show any hardwire connected rogue APs. It is blank everyday. Instead of seeing a blank report everyday, can I configure Prime or the controllers to o...

Hello,I'd like to create a guest wlan with no L2 authentication and L3 web auth. I want to user WLC 2504 internal user database, creating users with a lobby Ambassador account. With a single username I want to web authenticate simultaneously 30 to 40...

I have had a very strange problem when we have been trying to upload dwg floor plans into prime 2.1.We have found that some are in a format that causes the web server to crash and burn and we have to stop and start the whole server from the command l...

HI all,I have a challenge with silent clients behind a 3602e bridge.I have today autonoumous WGBs connecting to RAPs where I have a static bridge entry of the silent clients MAC so what ever happens with the WGB or controller the MAC always gets to t...

Hi guys.I have a cisco ISE solution implemented in my network.I have a some issues using profiling, because some devices aren't recognized when used the same version of system operation. For example windows 7,8 and 8.1.Some devices are recognized for...

Hi, I just upgraded to Windows 10 (from 7) and find that after upgrade, wireless is extremely slow/next to useless over the Cisco 1142 AP. Testing Win 10 with an Inteno (low end) ap, speeds are normal. Other Clients on the Cisco 1142 ap work as norma...

Hi, Looking at a Cisco router that could support these protocols? • DS-Lite (Dual Stack Lite)• 6rd is tunneling IPv6 in IPv4• CGN (Carrier Grade NAT) Was thinking ASR-9001 but not sure what else can accomplish this. Thanks!