Wireless

I have a hand few of really old 1130's, manufactured prior to when MICs were installed. In anycase I wanted to convert a few of them to lightweight for use in a remote location with a 4400 we have laying around. Long story short, during the upgrade p...

we have installed new WiSM2 in Cat6500 and both WiSM are in status "started keepalive".DESTGSW001#sh wism statusService Vlan : 192, Service IP Subnet : 192.168.250.65/255.255.255.248      WLANSlot  Controller  Service IP       Management IP    SW Ver...

Hi there...I was wondering how to get wired client info on maps.. they seem only to display wireless clients.Actually im looking for a overview when displaying a location and get the count on wireless and wired devices , that's all.Ive added the swit...

I have a large amount of internal 2602i and external 3502e Access Points at one of my sites,  I have the following Antenna AIR-ANT5160V-R for 5GHz and AIR-ANT5160V-R for 2,4GHz these have one cable per antenna, plugged in as follows 2.4 in port A and...

Hi, During an installation, one of the Rack release Latch of a 3355 got damage, is there Andy way to remplace tus piece?Thanks

                   Hi,I am having wlc 2504 with S/w version Software Version7.2.111.3I want to add community name uner "snmp v1/v2c"My requirement is : my community name will be the same but Ip/subnet will have 3 range & which I need to putBut I am o...

Hi All,Need help to understand how the CAPWAP tunnel work when one in the bundled (group of 4) port from portchannel group was shutdown.Here's the logical diagramAPs <-> Access Switch <-portchannel-> Distri Switch <-portchannel-> Core Switch <-portch...

Hi All,Today i am facing issue with mobility group. i checked and found  control and data path is down on foreign controller.I am able to ping anchor controller. Required ports are open on firewall but mping and eping fails. Any idea whats wrong. On ...

HiI need Admin acess to my AIR-AP 1042N configuration only for a Enthernet interface not Wreless ?Do you have any idea ?

We recently added a second ssid at a remote site AP but the clients cannot get an IP. They get associated to the AP but no IP.The ssid we added is using the default vlan 1 which is where the dhcp server is located.The other ssid vlan 101 is the visis...

AIR-SAP2602 APs operate as autonomous or standalone APs by default or design. Is it possible to convert them to lightweight APs?

HelloI want to get simple mac filter at certain WLAN with psk authenticationI have such at my home cisco881 - MAC-based ACL apply to the radio interface.I don't find how to make MAC-based ACL at 3850.And I don't understand how to use class-map type c...

Hi All,I have a customer that presently uses the cisco meraki wireless solution and would like to have a NAC appliance installed in there environment. Will Cisco NAC support the meraki for access control?