Wireless

Hi,I am getting this message on one of my AP's. I have 3 setup already, one acting as a WDS. But this one AP keeps giving me this message. I even went so far as to copy the config down from one of the working AP's, changed the name and IP in the conf...

Greetings,In my wireless system I have 3 Cisco 1100 access points with the same SSID. I'm using Mac authentication only, and I have several different users. In each AP the Mac local database changes. For example user A and B can associate access poin...

Hi,is it possible to configure EAP-FAST using the local authenticator RADIUS on AP ??? Is there a docs link on CCO ???I've tried to setup the scenario... the PAC from the Local Radius Server is received by the ACU client, but then when it starts the ...

I am using an Aironet 1200 AP. I set an IP policy to block port 80 on the wireless side however it blocked me out too. I have tried to do a reset but it will not reset. I have also tried telnet but it will not connect that way either. Does anybody ha...

HelloI have a strange behavior in my lab. I use an ACS 3.3.1 which is installed on Win2000 AD-server. The ACS use the ms-database for wireless user authentication. Every time, before I get the gina windows, the Wireless clients tries first to authent...

hi all,if i don't use transparent proxy isa (because i don't want to loose https fonctionality)can bbsm nat internal private addresses?thanks

i am wondering if there is an ap setting that i am missing. i have configured mobility groups with the wlsm, i have all of the aps authenticating and for my initial tests i have hard coded ip addreses. i have done the walkabout surveys with the wlse ...

It used to be that on a 54Mbits 802.11g network if one client is associated with 11b 11Mbits the every client on the access point works on 11Mbits. Is that correct for even the newest cisco Access points?

do i need a radius server if using prepaid codes in bbsm? or can bbsm alone make this?

I was attempting to installed a 1200 series AIR-AP1232AG-A-K9, the unit has a 2.4G and 5G antenna base and a spot to add antennas. The other WAP's I have installed from Cisco always had an antenna included. When I installed it and configured some wir...

Hi, I've upgraded 8 1310 bridges from 12.2(15)JA to 12.3(2)JA using the following CLI command: "archive download-sw /overwrte /reload tftp://xx.xx.xx.xx/c1310-k9w7-tar.123-2.JA2.tar". The upgrades seem to work fine, however, when I do a "show ver" an...

Hi,Can anyone recommend a 802.11g wireless print server for a HP Laserjet 4350N that fit into a Cisco Leap and WPA enabled network.Many Thanks.

I need to use the same access point for internal (secure) access and public Internet access for guest users.I used to do this just by trunking on the AP1200 and use two isolated VLAN<-> SSID pair separated by a Cisco switch. Now with the WLSM, I ever...

We insatalled 9EA AP1200.And we used ACS3.3 Radius server and WDS fastloaming. But yesterday, 7EA APs are hangging. All LED is green and do not operation. We repowered 7EA AP. Now all APs are good dondition. Why APs were hangging? And Why 7EA APs wer...