Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Dear All, I have C9115AXE AP which is running on firmware 17.13.0 and i want know that it is supported join on C2504 Hardware controller ( controller running on 8.3.150 version ) ? I also referred escalation matrix of wireless solution but not able t...
I'm in need of help with why my new 9th Gen iPads will not register to Meraki MDM solution, but older ones will.Did I miss something.Thanks
Resolved! Workgroup Bridges and DNA/SD-Access
Should wired clients connected to a workgroup bridge have any issues on a network using Cisco DNA and SD-Access? I'm just curious if identification of clients or applying an access policy to those clients behind the WGB would be a problem. A curren...
Resolved! Clients Bouncing from One AP to another
Hello team, I have Cisco Aironet 3500 Access Points running software version 8.5.151.0 and AP model AIR-CAP3502I-A-K9. I see clients experiencing intermittent Wi-Fi connectivity. when I check in Prime I see clients bouncing from one AP to another in...
i Looking to test the in-service upgrade, but it seem the SMU is missing from the Software Management. Running 17.9.4a in a HA. (don't know if this options is avlaiable in HA)We do have DNA Center, but not had it long, if this can be used?Cheers in a...
I am updating some python scripts for a customer and they will be deploying 9136's soon. I need to know the exact syntax that a C9200MGig shows when a 9136 shows up on the sh cdp ne.
Hello everyone.I have set up three access points 2x AIR-AP3802I-B-K9 and AIR-CAP3702I-A-K9 running 8.10.180.5 with one 3802i acting as ME controller + ap, while others are lightweight members. They're also members of the same AP group with single SSI...
Hello all,I'm troubleshooting some poor voice performance on a large network. Looking at some traces taken from my WLC, it looks like clients are going through authentication each time they roam to a new AP. However, I don't have much experiencing pa...
I'm wondering has anyone ever experienced increased fan speeds with attached Meraki CW9164i Access Points. I've checked temperatures and operational fan speeds and all are normal. Inline power is maxed to 30.0 watts per port. Total Power utilization ...
Hi All,I don't know if anyone has similar issue with my setup, client not able to get IP upon checking on the Wireshark, it's not able to discover the DHCP server. WLAN and Policies, Site properties and RF properties are setup correctly, created VLAN...
Resolved! 9120 AP not able to join 9800 WLC
My access point (9120) cannot join the WLC (virtual 9800). In the log from the AP I see the following: [*03/16/2023 07:05:40.0000] CAPWAP State: DTLS Setup [*03/16/2023 07:05:40.7090] First connect to vWLC, accept vWLC by default [*03/16/2023 07:05...
what does enabling the above check box actually do?
Hi Everyone,Could you please help and let me know whether the Cisco 3802I AP supports Cisco 2960 series PoE switches?
Hello community,I've a wireless network done by 150AX and 151AXM. It works fine. Now I've to add on the same network a CBW 145AC because need few eth ports in an specific area.Is there a way to do that ?Thank you in advance for your time and support....
