Dear All,Consider I have one WLC and few AP's to be installed on my premises. My requirement is to create two SSID's as Secure & Guest. I want to restrict guest vlan to only access internet while Secure vlan able to access whole corp. resources. How ...
I would like to setup three Aironet 2602I-A-K9 WAP in my office. Being new to Cisco WiFi, it appeared that I HAVE to have a WiFi Controller to make this work. Is that a requirement that requires me to also purchase a WIFI controller?
Hi,I am trying to setup SSO between my primary and secondary 5508 controller, and it doesn't appear to be working. I lose connection to both devices after the reboot and then have to console in and disable redundancy manually to regain connectivity. ...
Hi,I am wondering why the APs don't join the controller even though the APs and WLC are in the same subnet (VLAN245). I consoled to the AP and there was a message '%CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an Ip'. I conne...
HiWe have several controllers on 1 site one, we seem to have a problem when roaming, the device getting a new IP.We've since added a couple of mobility anchors for a couple of companies which are working no problems.What I have noticed is that our ow...
Hi everyoneI have question about syslog on wireless controller. I need to know what is information in the syslog from controller. I had read paper in the community some siad it has not much in the syslog but it has not detial what is the information ...
Hi Guys,Today I want to build a wireless bridge using AIR-AP1131AG (running WLC) and TP-LINK wireless router.The result is failed. May I know AIR-AP1131AG is support bridging the wireless connection with other vendor's access point or not?In the TP-L...
We have a site that would like to have controlled wireless guest access.Approximately 15 access points would be required at site and they have an ADSL2 broadband connection thatalso requires a router.I have looked at the 800 series ISR with adsl port...
We have a customer is a hospitilized environment.Since two months they work full time with the new Dutch Electronic Patient Dossier.We installed 3 Cisco 5508 controllers, version 7.0.230.0 last year on a HP-switched network on a layer 2 mobility doma...
Is it possible to link up a lwapp to TPlink router through bridge mode or repeater mode, i think bridge mode is more reasonable.As some experience guys suggest it would be working if one ap set as Access mode and the remote one set as workgroup mode ...
Hello Guys thanks for reading me again... I hope every one be ok, and I hope you can help me with this problem.I Want to deploy a WLAN with 2 sites one the Central and the other one the Remote. In my central site I have this equipment:2 WLC 55081 Swi...
Dears,Im having a problem using AIR-ANT24120 (12dbi) and Cisco 1242AG indoor , when ever im close to the AP and try connecting with laptop it shows a very poor signal and when im just a few steps away there will be no signal detected at all.Now i've...
Hi all.I`m configuring new 2504. I updated it to 7.4.100.60 and enabled LAG.I want to configure interfaces "ap-mgmt" - for AP management.(Cisco Controller) >config interface create ap-mgmt 69(Cisco Controller) >config interface address dynamic-interf...
Hello, help me pls, how can be disabled "stop-on-failure" feature on Cisco AP2600.Thank you in advance
I recently purchased the following license: L-PI12-LF-100 to add 100 additional AP licenses to our current appliance. When I tried to apply the new license, I received the following error:"Unable to add any license without an BASE license"This system...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 10-15-2026 05:58 PM | ||
| 10-12-2026 06:46 PM | ||
| 09-30-2026 07:34 AM | ||
| 08-10-2026 11:32 AM | ||
| 08-06-2026 09:29 PM |
| User | Count |
|---|---|
| 5 | |
| 4 | |
| 1 | |
| 1 | |
| 1 |
