Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Dear Sir,I am new in Cisco wireless first time i am implementing it.I configure redundant controller and two SSID one for the guest users other one for corporate user.Guest user i am using PSK with access list and its is working fine no issue.Corpora...

wajahatkhan by Community Member
  • 687 Views
  • 1 replies
  • 0 Helpful votes

I have a Cisco WCS server with two WCS-Plus-50 licences installed. unfortunately, I purchased the wcs-base-50 and wcs-plus-upg-50 as an attempt to add additional AP licences to the server however once you have the plus licences installed on wcs you c...

Hi,I have a 5508 wireless controller running version 6.0.199.4 (the image installed when the device was shipped) and I am trying to install by tftp version 7.3.112.0The issue is when using tftpd32 gets to 82% transfered then fails with the error "% E...

Hi buddiesIs possible, in WLC or Cisco ISE, limit the simultaneous login?Example:Use A has laptop, iphone, ipad, android table and android mobile. Today, the user can login in corporate wlan simultaneous (with same user/pass) in all devices. The cust...

I have a bunch of 1242 access points that we replace with 3500s. Does Cisco have a good program to reuse these devices? We tried trading them in but for some reason it never pans out.Sent from Cisco Technical Support iPhone App

Dear experts:I want to disable the MAC authentication that is configured in my Aironet 1200 Cisco Access Point, now set to "Local list only". I want that any wireless device can connect if the user knows the wep password.I cannot find the option to d...

mrclinker by Community Member
  • 661 Views
  • 1 replies
  • 0 Helpful votes

We have installed a WLC440 at a school with 30 1131 APs. Only 3 showed up under Wireless tab, and others became rogue APs. Where and/or what do I need to change on the configuration for others to join properly? Have matched the configuration on this ...

Hello,I have a wlc 2504, several indoor 3602i using Cisco 7926. The APs are in flexconnec mode, signal looks good from the 7926 site survey too. Good coverage anywhere from -50 to -65. I can be standing directly under an AP and the 7926 will loose ne...