Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I'm monkeying around with an 881-W. Clients can associate and authenticate to ssid 'test', but they cannot get a DHCP address. Clients plugged into f 0 - 3 get DHCP addresses just fine. I've looked at a lot of different guides, ran debugs etc. When w...

jdevoll by Level 3
  • 3638 Views
  • 5 replies
  • 0 Helpful votes

Hi Guys,I have a WLC 4402 with many APs connected. Most of the APs are LAP1121 and LAP1131 and are working using 802.11b/g.I tried activating 802.11a but for some reason its not working. I see under the Monitor tab that the AP's "802.11a" interface i...

jonathan by Community Member
  • 1114 Views
  • 2 replies
  • 0 Helpful votes

What is the best solution for the following scenario:We have WiSM( with two internal WLC's) at HQ & AP's at Branch. Each branch has DHCP Server which has to provide IP's for branch Wireless Users.We have configured one interface (10.39.178.1/24 - DHC...

I have a brand new NCS Appliance. we ran through the setup on the console and we can successfully ssh to the box, we can ping the box, but when we go to https://<ipaddress>  nothing comes up. It just says that it cannot display the webpage. Any thoug...

kknuckles by Level 2
  • 4572 Views
  • 7 replies
  • 0 Helpful votes

Hi GuysSmall Auditorium room needs to be faciliated with Internet access supporting around 25 users. ISP provided a Ethernet drop cable to the room and shared public ip/mask/dns/GW.  The area in auditorium is open one standalone AP seems to be ok. wh...

Hello,I was wondering if its possible to setup the Cisco Aironet 1260 as a WDS master with radius and another Cisco Aironet 1260 as a slave for seamless roaming. How many slaves can a WDS master handle?Thank you in advance.Maarten van den Enden

maarten182 by Community Member
  • 1077 Views
  • 1 replies
  • 0 Helpful votes

Resolved! WLC Eportal

Does cisco controllers allow you to redirect to more then one Eportal? If so, do you need to have more than one SSID?(:Sent from Cisco Technical Support Android App

mdshelton1 by Community Member
  • 1596 Views
  • 4 replies
  • 0 Helpful votes

Hello,I'm currently investigating on Aironet 2600 accesspoints.There are two model numbers, CAP2600 for controller based and SAP2600 for standalone/autonomous.My question now is, when I purchase a SAP2600 (=autonomous model), can I later convert it t...