Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
Dear All,I need a basic explaination on setting up the following controller:Cisco 5508 Series Wireless Controller for up to 100 APs802.11a/g/n Ctrlr-based AP w/CleanAir; Ext Ant; E Reg DomainFor Mobility i want to settup the device such that the SSID...
Client has a building that is located 300Ft apart and would like to provide IP communications for 3-4 IP hadsets back to an IP PBX. They do not want to dig up the parking lot so we proposed using a wireless bridge. I noticed that Cisco discontinu...
Hello,what about law impact, if I have Access-Points in China or Russia (example), the controller in America or Europe and use a CAPWAP Tunnel between them?Sven
Hi,After I initial MSE with the wizard. MSE take so long to start the service (more than 1 hour) with "Starting MSE Platform, waiting to check the status"Then I decide to reboot the appliance, after that MSE shows the message "Traceback (most recent ...
Hi,after an upgrade of NCS 1.1.1.24 to CPI 1.2 on green field, it was not possible to reuse the GUI. During the upgrade, I''ve shortly seen an oracle DB error, but the upgrade was going through, without problems.At the end, it was not possible to us...
Hi Experts,We have 3 different AP1552 in sama AP group. we can reach all of them via controller. None of them have alarms on ita nd they have the exactly the same configuration.However, only one of them broadcast SSID, other AP's does not broadcast S...
We have a core switch ( 3750 ) , a wireless lan controller , access points , DHCP/DNS/AD server.Ssid's configured on the controller need to be authenticated with username & password, but the database of authentication needs to be in a radius server c...
Is it generally a requirment to support both WPA and WPA2 for enterprise?Sent from Cisco Technical Support Android App
Hi Guys.Setting up a multi floor WLAN using a 6500 WISM Controller. Each floor has an AP group with the floor WAPs assigned. Each floor has a VLAN and the WLC has an interface configured. Each floor has a WLAN configured with the s...
i would like to ask if a cisco aironet 1162 access point can work without those antennas as well as an access controller.thanks in advance
Hi Members,I have a Cisco Flex 7500 in my datacenter and I need to connect 100 sites , each site with 2-3 APs , each side has its own network and is independent of other sites , the site only need to comunity locally and do not need to access any cen...
Are there any training classes for the Wireless LAN Controllers, or using NCS, or using Prime Infrastructure?I've seen a few books for WLC but NOTHING for NCS or Prime Infrstructure. I'm so frustrated with NCS and PI that I'm ready to scrap trying to...
Hi;When i try to get voice related reports or voice audits in NCS, i see an error like "Check that VoWLAN SSID exists". We have a SSID that is only for voice. So how can i mark an SSID as a VoWLAN? Is there any way to configure it on controller or sh...
HI all I have two issue with this configuration : First :I tray to login to my SSID thru the Laptop ( you can find the Password in the configuration) but the laptop cannot recognize the Password or (encryption) Second : after making the Switch port...
How do i get the 12.4 code to assign a dhcp address to my ethernet interface from my server? I deleted the default config on the 1141 and searching has not turned up anything useful.
