Wireless

I have a small wireless network of one wlc 4402 and 10 little access points This morning, after a thunderstorm raining a   whole nigh, only 9 of them is visible on my wlc.I've tried to reset the one that is missing but with no success - it didn't ap...

Is it possible to import new (IEEE) vendor code list to get correct information regarding clients MAC-addresses? There are too many client vendor codes reported as "Unknown" lately......Running 6.0.196.0./jonas

I bougth cisco Aironet 1250 series few days ago, after configuration window 7 clients were able to (Associate) access interrnet through it but window XP clients didn't access internet(associate) through it, after all troubleshooting i decided upgrade...

Hi All,i have to setup WCS Enterprise on several servers with a 1000 AP License and a Secondary Server "in the Middle". Can anybody help me with Informations regarding Licensing, how to setup the Secondary Server, in which step of the Installation do...

We have two 4404's and WCS. The 4404's are almost maxed out. We have an addition 4404 which we would like to add to the group of 4404's. What is the best way to do this?Thanks

Hi,It seems that the 2100 models do not support wired guest access. I wondered if the following work around might work?We are using a 2106 with a wireless guest network anchored to a 5508.Would it be possible to configure an Autonomous AP in WGB mode...

I have a fully functional wireless network up and running, but some of my aps seem to be dropping packets.  If I test by doing 50 pings, at least 10% of them do not go through properly.  Any ideas?  I have tried changing the channel and its width, bu...

Hello,I am having a design problem: we are having a mobile cart with a device sitting on it. This device is configured and only supports a static IP (no DHCP support). The device is connected to a bridging AP and this AP associates to the WLAN infras...

Hellowe are looking forward to monitoring the cpu, environment variables and the memory of a wireless lan controller via snmp. but we are not able to find in the mibs the right oid to manage this.can the exact oid be given in order to monitor these t...

hey all,is there a way to find out when an Access point what manufactured? i know you can find out the age of a switch via its S/N just woundering if an ap is the same?

Hello,I recieve the same critical alerts in WCS the same time each week on the same 2100 series WLC:Port '3' is down on Controller '10.x.x.x. - Controller Name: WLC1Port '4' is down on Controller '10.x.x.x. - Controller Name: WLC1Port '5' is down on ...

Hello,This is the first time I use the forum.Our deployment has the average of 900 users, 110 Access Points and 6 controllers.We´re using access points 1131AG, 4402-25 Controllers and code version 7.0.98.0.The majority of our users have 3COM PCI a/b/...