Wireless

Is it possible to configure two 1300 series bridges at one location, each handling a bridge link to another location to BOTH backup and load balance for each other should one of them fail?

HI In my site i am running WCS with 5.0 version on a Linux server .From past 5 days i am seing the WCS application is not responding properly .Once i restarts the server it is working for some time and again its getting unresponsive .Did anyone faced...

Does anyone know how an ASA and a guest anchor 5508 will interact if I setup an Active/Active failover pair with physical interface redundancy?  I see from documentation that I can create a logical group in the ASA to bond physical interfaces togethe...

Hello together,I try to find a general solution to the following problem:Cisco WLAN environment, >50 intelligent APs, >300 WLAN User, multiple SSIDs. Behind every SSID is a different VLAN. DHCP enabled on the clients. The users standard of knowledge ...

Due to lack of address space, I have to go to NAT for our wireless guest users.Are there any limitation with WLC/NGS when comes to NAT?I have four 5500 WLCs, should I put them in 1 mobility group, at 2 different locations?ANy doco on WLC NAT would be...

Hello all,We have just configured MAC Authentication for our wireless WLAN via the Cisco ACS Radius Server.The server is configured with a list of MAC addresses to allow on the wifi network and the controllers send authenticationrequests to the radiu...

Hello,I have a problwm with a WLC 5508If I define a new WLAN with a ID greater 16 the WLAN will not be send out by the AP Is this a bug or a feature? Udo

We are experiencing some issues while upgrading from WCS  7.0.164 to 7.0.172. For some reason, everytime we try to import the 7.0.164 database, the 7.0.172 restore process aborts with:Waiting for database to become idleTo Version 7.0.172.0Invoking up...

We just got avaya wireless phones to connect the WLC and they require us to enable Admission Control (under wireless--> 802.11 radios), but when we click the checkbox we get an error message saying : "unable to modify media config while network is op...

Dear All,i have WLC 5500 with 50 AP Base license with LAP 3500i APs,so, do i need license for the WLC to work with the cleanair technology even it software ver 7  ?????and also i have WCS with base license so do i need a license also for the WCS to w...

Hi All.I have one upgrade question regarding WISM 2 and WS-6509Today my IOS is:System image file is "disk0:s72033-ipservicesk9-mz.122-33.SXH4.bin" Do a have to upgrade to 12.33 SXJ, or will 12.33 SXH4 work ?Can anyone help clarify?Thx !

Hi i have 350 WAP (1142n) running of two WLC 5508 (IOS version 7). WLCs are not located on the same subnets/locations and are not configured as mobility groups. The vlan ids on both wlcs are not identical, eg:wlc1 - vlan47, WLAN id 5wlc2 - vlan47, WL...

Hi All, For some testing purpose, I need to generate some MIC failures in the controller. How can I generate these failuresThanksNikhiL

I'm trying to configure my Linksys E2000 to be an ethernet attached wireless device to use on computers instead of dongles, etc.  I don't want it to route, just act like a Wireless card.

Hi all,Is the WUSB600N usb adapter  based on ralink RT3572 chipset?Thanks.