Wireless

Hello!How can I upgrade an IOS image on my LWAP 1142? I have also WLC 2125

Should there be any problems streaming multicast HD video (3 mbps) wifi to 5000 standard HW tablets w custom app software in a closed arena? Which Cisco gear to use?Thanks

Hi there,I have 1200 AP, for some reason its radio interface led blinks red all the time. So i upgarded to version c1200-k9w7-tar.123-8.JEE.tarStill no luck. One thing i notice is in my GUI radio interface didnt shown up. In interface tab i can see o...

Hi, i would like to know how can i improve the speed in my HWIC HSPA to get the 20Mbps that the service provider has given to me.Now i just can get 3Mbps and that is not enought for a Branch office.There is the "sh conf", "sh cell 0" and a speedtest ...

Does AIR-CT2504-25-K9 spupports AIR-LAP1262N-E-K9  Access Point? How can I check this?

How do you change the timeout value on the HWIC-3G-CDMA interface card? The connection times out or disconnects after a minute or two when there is no traffic or activity going on. Is there a way to change the timeout value so it stays connected long...

I have deployed a Cisco wireless environment at one of our sites. The problem is that we are rolling out new motorola handhelds using windows 6.1 are not authenticating with the ACS. I have copied the same config as it was with the exsisting  wireles...

Running WLSE 1.3 and it shows No Data Available. Checked the task history for Inventory collection and it is not collecting. All the processes are running. Unable to gather data. SNMP community strings are configured and devices are accessible (AP350...

HiNot sure if this is the right forum, but I'm completely new to Wireless networking.I've been asked to specify equipment for a client to meet the following requirements. Campus WLAN (employing thin AP’s with controller) Present 2 x SSID’s (one for c...

Hi, is there a way to get the same info as listed by the IOS command: show dot11 associationsusing snmp under Linux? The closest I have found is: snmpwalk -v1 -c public 172.24.24.218 | grep RFC1213-MIB::atPhysAddressAnyone?

Hello, I have a WISM running version 7.0.116.0. I want to see if the subnet declare for my dynamic interface is good. So i need to now how many client use this interface. How can i do this ?Thanks, Vincent.