Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I have two controllers and am getting the following errors - version 5.3(5).CNYNYC82-WLC-2,50020,Mobility: The number of peers is less than the total number of loaded controllers in the config file. It is strongly suggested to load all controllers in...

cbradt by • Visitor
  • 1152 Views
  • 2 replies
  • 0 Helpful votes

Everything had been running fine for a month or so...  Just recently, I began receiving critical messages from the WLC saying that the AP went down...  In the logs, I find the following for everytime I received such an e-mail:*spamReceiveTask: Jun  1...

hgrossman by • Community Member
  • 1032 Views
  • 1 replies
  • 0 Helpful votes

Is there a method for finding, in a decently readable way (i.e., not "show run-config" or "show access-point-config") a list of all access points' primary, secondary, and tertiary controller preferences? A certain report from WCS, a script, a command...

m.glosson by • Level 3
  • 740 Views
  • 1 replies
  • 0 Helpful votes

Hi there,We are using a Cisco Wireless Network with WLC 5500 (6.0.199.0) and AIR-LAP1142N-E-K9 Access Points.Our Call-Center reported several problems with WLAN-Phones having interruptions on calls. First i checked the "site investigation" status on ...

Does anyone know if there is an upgrade path from the WLAN 4402 to WLAN 5508? OR A proceedure to get the AP's to join the new WLAN?  We currently are using a WLAN 4402-50 and have maxed it out. We are plannning on purchasing a 5508 with 250 licenses,...

tbulliard by • Level 2
  • 1028 Views
  • 1 replies
  • 0 Helpful votes

Hi,I'm looking for a solution (WLC 4400) which enables employees to browse to a custom made webpage, where they can create an account for company vistors to access the internet. It's important for the employees not use any login credentials, they arr...

tim_buster by • Community Member
  • 1333 Views
  • 3 replies
  • 0 Helpful votes

Resolved! Cisco WCS

Hi,we are gong to deploy a wireless access points on a few sites. We need to find the coverage so that we can place the access points on the right place. We need to do this for a number of sites and a professional survey for each would be expensive. ...

Hi, I would like collect information from Access Points using SNMP. My application to do a snmp get for each device.These APs are connected with a WLC and this WLC has the SNMP credentials to read/write configured. Is possible replicate the SNMP conf...

luisbicalho by • Community Member
  • 1309 Views
  • 2 replies
  • 0 Helpful votes

After upgrading my WCS to ver 7.0.172.0, im unable to create new floorspaces, using the same .dwg files i used in 7.0.164.3Does anyone have an anwser for that ??

hrandl by • Frequent Visitor
  • 920 Views
  • 1 replies
  • 0 Helpful votes

Hi,I have a question concerning 3G band locking on a Cisco 881G, for several routers we see that the router locks on th GPRS band although  UMTS/WCDMA is available. This is for me the first strange item, I would think that the routers locks on a bett...

Review Cisco Networking for a $25 gift card