Wireless

Hello, i'm configuring 3 AP 1131, with 2 profile Guest and Inoffice. the 3 AP are going to be connected to a 3560 and they are going to have Vlan and a 2811 is going to be configured as a DHCP.now all i can see when i search for available network is ...

What is service port interface in WiSM? I know it is used to communication with Supervisor Engine but just want to know in details ?Please helpthnxsubharose

The options I have found for these 3G cards is the the extension base that uses the Swivel Antenna (3G-AE015-R) and the ceiling mount (3G-ANTM1916-CM). Both of these are indoor solutions. The problem is that the building we are trying to deploy the ...

Was unable to assign IP through CLI. DHCP was assigned from Linksys RVS4000. I am able to access GUI fine. Basic default unsecured setup. Lights correct, but no connectivity.Will the AP work with an internal IP or must it be static?Do you have to use...

Hello,We have a Cisco ACS appliance version 3.3 (I know, it is older).We have a cert7.db file located on an FTP server ready for the ACS appliance to download so it will use secure ldap.No matter how we enter the information to download the certifica...

I can't seem to turn off bridging or find a config for an autonomous 1250 with IP routing. I'm trying to convert it to lightweight, but without IP routing it's making it difficult to download the image from a TFTP server.

We have deployed Lightweight AP with WLC. But we do not purchase WCS. Is there a way to snmp poll the WLC to obtain the number of LAPs joined to the WLC? If so, what is the snmp OID to poll?Thanks for the help

Hello,I have a AIR-WLC4402-25-K9 controller, with roughly 20 APs. Whilst on the WLC GUI I can see on the 802.11b/g/n Radios monitor screen that one AP has 'Load Profile' failed. The rest are fine. Could someone please tell me what this is, what it me...

Does anyone have a part number for a 2100 rack mount kit, cant find it on Cisco anywhere? Is it the same as for the 526 the ACS-UC500RM-19=

We have a problem when trying to access our domain via cisco LAP if the user uses the £ sign in their password It fails chap authentication. Does anyone know if there is any restriction on the use of the £ sign. It appears to only be that char.

Does anyone think this is feasible as a solution...Problem Definition.1) Machines all use the netware Client and authenticate to eDirectory initially, then to AD.2) I want to use ACS, not Free Radius.3) I don't want to use a 3rd party supplicant.Poss...

Where in the WLC do you adjust the 1522 AP for link-distance? Will it extend as far as 13 miles?