Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
I am having a problem with users taking a longer than expected to receive a DHCP IP address from a local dhcp server. Once they receive an address the signal is very low for about 30 seconds and then it will raise to an "excellent" signal.Access-poi...
I'm involved in a wireless LAN project where we need to provide free Internet access to all passengers in a large airport. We are well on hour way deploying more access points and preparing controller configuration.I would like to here from people wi...
Hi,I'm currently trying to upgrade my wcs from version 5.1.64.0 to 6.0.181.0. but every time i run the installation file it tells me that there are multiple copies of the WCS installed on the server and i can't upgrade i can only start a new installa...
Hello,I've recently installed WCS 7.0 on a windows 2003 server and set the time zone on windows to be my local time, UYST which is GMT -2, but when I check on the WCS all times are on GMT not on UYST. Now if I change the time zone on windows to brazi...
Hi,I am planning to buy a cisco 1260AP so I can connect external antennas.My choice would be the MAST antenna AIR-ANT2506Do I need to buy 3 antennas?How do I install them on the mast? All 3 antennas on the same mast with the same height?If somebody ...
After upgrading three 5508's (which support 150 AP's) from WLC/WCS version 6.0.182.0 to version 7.0.98.0, our users complained about low signal strength. Our pre-upgrade RSSI benchmarks confirmed a decrease of -10dB to -20dB signal strength across ...
There are set of 1131G access points which belong to different segment than management couldn’t be registered on Wireless Controller (Catalyst 6509 WISM). However access points allocated in same range of management network is easily registering on c...
Hi,I have a streng situation.I can ping IP address of WLC and AP from LAN.Also the PC connected through WiFi is responsible but of every one minute is discarded one ICMP packet.This situation is not only to one PC but on others connected to WLAN.When...
Hi we have a 5508 series controller, we're using port 1 and 2 with LAG enabled. If I unplug the cable from port 2 anything that relies on DNS starts failing, I'm able to ping based on IP address just not by name. when it's plugged back in it's fine. ...
I am running WCS 6.0.170.0 and don't have the option for an AIR-ANT5160V-R. Is there a way to add additional antenna's to the WCS or do you have to upgrade your software?
Hello,On a LAP for an availibility, I configured the name of the primary controller and I can configure the IP address to.I've a doubt: should I learn the IP address controller: the management IP address or the IP AP-management ?Thanks you.Lorenzo
HII bought an router cisco EPC 2425 but I have some problems with my Windows 7 Home Premium.Is router EPC 2425 is compatible with Windows 7 Home Premium?ThanksTiago
Hi,Can the Aironet 1520 access point be field upgraded from Autonomous to Unified (LWAPP) mode like the Aironet 1240?Thanks.E
/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-parent:""; mso-padding-alt:0cm 5.4pt 0cm 5.4pt; mso-para-margin-...
Has anyone seen or heard of an issue with the internal DHCP server in 6.0.199.4? We upgraded today and the internal DHCP server on both WiSMs went nuts. Client address assignment was sporadic, and eventually non-existent. Client would get associat...
