Wireless

Hello,Is there a way to stop RIM (Blackberries) and iPhones, Nokia's and Sony from connecting to the guest network as they hog IP addresses? I would like to do some "range" mac filtering or sommat, but only for iphones, and rim, and mobile devices, ...

Hi all. I am hoping someone can assist me with this.I have 10 APs (all 1242s) and a WDS (also running on a 1240 Aironet). All of the APs authenticate to the WDS successfully. The WDS uses it's own local RADIUS server for authentication and there is...

I have a 871W I am going to use for a conferance in hotel. There will be 30-35 users. Not all will be wirelss but most of them will. How may clients can a 871W support? I also have a 1242 Aironet. Would I be better using that?

We use AP1230's as AP's and as workgroup bridges (WGB's) so we have Cisco on both ends of the RF link. We'd like to control the amount of upstream bandwidth from wireless clients while leaving the download side unrestricted.IOS on routers supports th...

"1252 both radios installed w/one radio enabled @ full N speed on 802.2af power"Are there any special instructions to make this work as described in the documentation for the latest SW Version 12.4(21a)JA1?"Support for 802.11n Performance on 1250 S...

I installed a Cisco Aironet 1200 access point for use with a few Macs, some old Dell D600 and iPhones. I have enabled both G and A netorks (tried various channels as well) and cannot get the old Dell D600 and/or iPhones (3G and 3GS) to see the netwo...

Hi,I have some Zebra printer with static IP Address, they are unable to connect to the WLAN, but if I enable DHCP required, the connect. In the WLAN configuration, I'm permiting static IP Address asignment.Any ideas?

Hi,I am Cisco WiSM consists of two Cisco 4404 controllers which is installed on the 6503 Switch. I am using Mac Address based authentication for clients to get connect.When i am adding a new client's mac address to one controller, it is not reflectin...

In a standard WGB configuration with a controller, can connect to the switch besides the AP WGB too another AP to allow wireless customers? That is, to have a wireless client connects with a AP in the WGB switch. View image

We are currently running version 4.2.62.0 on WCS and we are looking to upgrade. I've been searching for the proper upgrade path for this. I would like to go to 6.0 code. All the controllers will be upgraded to 5.2.178 once WCS has been upgraded. Plea...

Hi all,I cant seem to find the solution. The last act of our previous network admin was to reset the passwords on the access points before he left. Now we cant log in. I tried the mode button on power on, but the Cisco/Cisco login does not work. ...

Hi-it is written in the Navigator Hardware requirement that it is supported on a 3.2 GHz Intel Dual Core processor with 4 GB of RAM and an 80-GB hard drive. We already have a server available with Quad core Xeon E5430 Interl processor (2.66GHz), with...

Hi there all When you set users up on LA and you set a user to a "controller list", the entry on the listing always shows the account as active from the front menu even if the time has expired.You then go into the account and you can see the date has...