Wireless

Hi,I'd like to know if there is a constrain regarding what models of APs could be used as MAP or RAP in a mesh network. Every AP could be used in this kind of configuration? (for example AIR AP 1130)Thanks

We have a site with one WLC 4400 managing multiple AP1130,connected through Layer 2 D-link switches to Cisco router. We are thinking to have one SSID for internal users (get public IPs from Windows server) and another SSID for external users (using i...

I want to use the Aironet Site Survey Utility in Vista Ultimate 64bit. I have a CB21 card which the utility does detect. It does not show any access points or that the client card is associated.Any help would be greatfully received!Thanks in advance

We have a WLC 4402-12 that support up to 12 AP's. Can I upgrade this WLC to support more then 12 AP's?

I have purchased one AIR-MSE-3310-K9 and 100 hundred wIPS license to support 100 monitor mode AP (AIR-WIPS-AP-100)With the version 5.2, where can i install the license ? into MSE or into WCS?? and how can verify them? I didn't receive any paper licen...

I was reading the data sheet on the 5508 WLCs and was curious about this statement:"Service Port : 10/100/1000 Mbps Ethernet (RJ45) For High Availability for future use"Is this a future design feature so that the 5508s share a common backbone, simila...

WLC 4404 APs1142I have an AP that I dont want to broadcast our SSID but I do want it their. I want it to broadcast only our guest SSID. I have both in a AP group and can see both but is it possible to disable the broadcast for our SSID but not our gu...

We have a 4410n wireless n access point we are using for testing. Have a time getting it to power up with POE and a 3550 switch. I have disabled cpd and spanning tree. Only way to get the AP to power up is remove power from ether port and use DC adap...

Hi There,I have a setup of 9 1522 APs. RAPs=3 and MAPS=6 WLC=4404 Qty 1 (v5.2). All the MAPS have only one hop to nearest RAP. The problem is with one of the MAPs. The MAP shows good signal strength but the client traffic (even ping to controller man...

Hi,I'm looking a wireless site survey planner tool for multi floor office building to estimate the number of APs and location. Not the site survey after install APs.AigMagnet is excellent for single floor but cannot provide multi floor scenario via p...

Is there a way to find out if the AP is under utilize, over utilize or has reached its maximum load? We can see the controller's CPU and memory usage but there are no such reports for Access Points. Because of this, I was wondering if there is a way ...

Hi Folks,Running into an issue upgrading from 4.2.130 to 4.2.207, receiving the following error message and wondering if anyone has run into this same issue and if so what's the fix? Cisco TAC is telling me to reboot the C6500 chassis to resolve it.....

Can someone please take a look at the two configuration and tell me if there is some thing wrong or is going to work.thanks