Wireless

I can't find information about AIP-AP521 and AIP-AP1131 do they support 802.1p QoS and 802.11e Wireless QoS. I found one topic here: http://www.cisco.com/en/US/docs/wireless/access_point/350/configuration/guide/ap350ch1.html#wp1019578but it is not cl...

i setup a wlc 526 with 2 521 aps, all of them are connected to the dlink DI-624+ ethernet router which is configured as DHCP. The wireless seems ok, but when a pc connected to the wireless network it was unable to receive dhcp from the dlink router.p...

Hi, I have been working with WLAN controller 4402 for a while now however some strange thing happened this morning. all registered LWAP APs disappeared. upon rebooting, all of the APs came back (registered) but started disapperaring one by one after ...

Where can I get the VPN client software for Nokia E-Series Mobile ?

I have a Microsoft dhcp server (Windows 2000) on my network. Connected the 1130AG to a trunk port on a Cisco switch. The 1130AG receives an ip address from the dhcp server just fine. How do I make the 1130AG AP give out ip addresses to client worksta...

Hello, We have an outdoor wireless network working with two cisco 1300. One acts as a access point and the other one as a bridge. We would like to extend the coverage of the bridge... Is that possible? There's one spot inside where signal quality is ...

Hi all I want to configure AccessPoint to connect Weighing machines authenticate through the AAA server.the username is the MAC add of the machines and what shoud be the password.The AP already has some configurationdot11 ssid C4ABCD3_V60 vlan 60 aut...

I am trying to find if our new installation between Cisco 130 Bridges is good or not . Not able to find any documentation to read parameters . Can someone help?Following is the ouput from the bridge:show dot11 ass allAddress : 001b.2a30.1460 Name : C...

In the version of the Wireless Lan Controller 4.1, I can configure a captive web portal for the guest users??

Please,I want to offer for my client for IP telephony Wireless. The pattern is simple, I want to connect 10 mobile user to communicate with each other. What are the appropriate equipment cisco.

We currently are using a Cisco unified wireless infrastructure. The infrastructure currently consists of 2 Cisco 4404 wireless LAN controllers with 36 Lightweight Access Points. The Cisco 4404 wireless LAN controllers have firmware version 4.2.99.0 i...

HiCan somebody tell what for is this option:RADIUS ConfigurationCredentials Caching..............................DisabledI can not find any info about it. I guest this option cache radius credential on WLC and helps for faster roaming (without reauth...

I have two sites bridged with 1400 bridges.I wish to bridge a single vlan between the two sites. However I want to setup the bridges with management IP's on seperate subnets (the local management subnet for each site).The only way I can get this to w...

I am trying to set up a new WAP in a remote facility. This set-up is a mirror of the setup that we have in our corp office (with obvious differences that are site specific). I am trying to configure this so that there are two VLANs. VLAN 10 is set sp...

dear in which band and antanaa does cisco wireless phone 7920 works?