Wireless

We use several (80) wireless bootp devices in our network. They of course have been running great on autonomous APs but refuse to work on our WLC wlans. I did a packet capture on the vlan only to find that the wlc 4404 is retagging the bootp packet...

Here's our topology:1130 series APs -> 4400 series WLC (mgmt vlan 51, client dynamic interface vlan 360) -> Catalyst 4500 series -> DHCP server (vlan id 11)We appear to be unable to relay DHCP requests from a wireless client on VLAN 360 to the DHCP s...

We have an AP we will use for outside shows so it needs to be a DHCP server. I configured the unit with 192.168.2.2 address and the same gateway.Who do I configure DHCP server on the unit?Yuriy

My aironets are individually managed, I do not have the wireless control or management appliance or software. I just read where the ap can act as a scanner. Is this useful if its a standalone ap? What will it do? Will it report or show anything abo...

hello experts... scenario/setup:1240 lap's are already deployed and working. we, then, converted the 1230 ap's to lightweight with ios c1200-k9w7-mx.123-4.JA. we've upgraded the 1230 ap to c1200-k9w7-tar.123-8.JA.tar since the upgrade document recom...

My customer site is having issues with 802.11b clients not associating to a WLC 4402-50 controller that is setup for both 11b and 11g. 802.11g is working fine. As a test, the client's wireless mode was set to 802.11g at the user WIC Settings. But, it...

I get pages and pages of these in my syslog... yet everything appears to be wrong.. what gives?Nov 26 01:44:42.102 dtl_pdu_landd.c:400 DTL-3-PKT_TX_ERROR: Failed to transmit a packet of type 2,USP:291897344/288555008/288555008.Thanks!

Good morning! We just installed 2 Wism controllers and added several AP' which are working correctly. Yesteday we added 9 more AP to the network. The AP's are getting DCHP from the DHCP server not Wism's, the APs are reachable via ping from any loca...

Hello,We have multiple 1242 AP's (LWAPP) communicating with a controller back at the main site over a T1 (1.5Mb) connection. When bandwidth utilization is very high (close to 100%), wireless clients seem to lose connectivity for a short time. Netflow...

we configured multiple vlans in both base station and remote station.we connected base station to l2 switch configured as per requirment,but when i am connecting my p.c to remote client i am unable to communicate to base station+1)link up2)wen i am c...

Is anyone using RADIUS to issue out IP addresses to their clients. We want to issue IP's to clients from RADIUS according to the users ID authenticated against Active Directory. Has anyone done this?