Wireless

How much area do an accesspoint will cover? How many users do an accesspoint will support?

Hallo!Does anyone know - how can i make my access points (for example 1200 series) work with 802.1n? Will it be enough to just install new software on the old AP or i need to change hardware(for example chage all my AP to newer, which support 802.1n)...

Hi guys, i'm having some connectivity problems with an 1231 AP, and i have some question for you:Is ther a problem if the AP and the clients are on the same segment (vlan)? I have a configuration that looks like this:interface Dot11Radio0 no ip addre...

We now have two installations that utilize a unified wireless (WLC or WiSM - AIR-LAP1131AG, AIR-LAP1231G, AIR-LAP1242AG access points) that have been exhibiting the following IDS false alarms:Disassoc FloodAP ImpersonationWe have TAC cases going back...

Has anyone seen the WLC reporting its own APs as impersonating APs? I checked the forum and found one conversation relating to this and my 802.11a is set to Country already. But I am see ing this on the B/G side. Any thoughts?

I have a network composed of several sites running withOUT REAP (1121 APs). I'm using a single subnet for wireless clients in all sites (50 clients). All wireless traffic is encapsulated within AP management traffic to WLAN controller.I have a proble...

Hello all, I am having trouble configuring a 1410 bridge to accept clients. I am running SW 12.3(7)JA3. I set the bridge to Root mode and assign basic settings but cannot connect with a client. I can see the SSID broadcasting. Any ideas?

I am working in a project with VSAT communications in boats. I am faced with the issue of providing a single dish on a boat with a link to two different satellites, for back up purposes. I am very coincerned with the delays that may arise when changi...

Have been looking at BBSM 5.3 and can see that you can configure Foreign IP Address (which pickup static address in a range defined on Wireless Clients) but wonder if the BBSM can be configured for IP PnP whereby it will NAT the IP address of Wireles...

Hello,Have a set of BR1310G-A-K9-R with AIR-PWRINJ-BLR2 injectors, feed by P/N 34-1537-02 REVA0.If 1310 connected to injector, powered by the transformer (mentioned above)when power applied, red light between power plug and coax connector is red, no ...

as bridges, simultaneously? I can see two wireless links, one is 2.4 the other is 5.8. Can I use one 1200 chasis, with 2 radios in it, to aggregate traffic from each band to the ethernet port as bridges?Just trying to increase bandwidth and save on r...

Is it possible to set up a DMVP topology using a router?s inside interface o a loopback interface as the source for a DMVPN spoke?

I'm not seeing SSIDs for rogue access points any longer.WCS 4.0.96.0 Base + Location on Linux, two WLC 4400s running 4.0.206.0, no location appliances (yet). I'm sure I'm missing something simple but I'm not sure what.

I'd like to delete old access.log in WLSE. The access log's size so big.How can i deldte it? (/var/adm/CSCOets/log/access.log)

Deari have problem with connected to access point in the wireless network ,whoever when i try to connect to the access point 3 meter away from it its not connect and some times connect with low connectivity when i check the field i found a lot of oth...