Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
We are having issues with our AP deployment and was wondering if there is a way to increase the range and throughput without moving the AP's around. ALl of the AP's run in "mixed" mode so they support both the B and G standard. I though I read somewh...
While working on a 340 AP I upgraded the firmware per the "Cisco - Upgrading the Cisco Aironet 340 Series Access Point Firmware from the Console" instructions and upon completion of upgrade and a hard reset the system goes through Inflating of Enterp...
Hello,I'm trying to configure Aironet 1000 series and Aironet 1130 series APs to talk to a wireless controller card inside a 2811 ISR. I have a Catalyst 3550 L2/L3 Switch between my APs and the 2811. So far the Aironet 1000 series found the wireless ...
Does anyone know if the 1500 outdoor mesh AP has a site survey mode that allows its radios to work independently of a wireless LAN controller like the 1000-series APs do?
Is it possible, on an AP WDS Host, to switch the requests of authentication of terminals customers LEAP towards a LEAP server, and terminals customers EAP FAST towards another EAP FAST server?We use the same SSID for all terminals.Do you have already...
HiQuestion I have is related to the following setup. WLSM and access points (L3 roaming)incorporated into 6500 with FWSM. The FWSM is firewalling 2 wireless networks. Access points have BVI on seperate subnet with subinterfaces on fastethernet defini...
Is it possible to enable dot1x and voice on the same interface? If so which switches and IOS support this feature ? Any references to documents ? Commands that cannot be configured together :-switch voice vlan xxxdot1x port-control auto
Hi,I installed a version 2.13 on a new WLSE 1130 equipment and I'm trying to configure some "Group Management" under the "Device" tab. I need to create some "Subgroup Of" folder but the only choise is "root" so all the folder are on the root.Does som...
Currently using funk odyssey client and ACS server software with radius for wireless lan authentication to AD.Authentication works fine but fails to work when a user is forced to change a password after its windows domain logon has expired or when th...
What is the CLI command to disable telnet access to Cisco 1200 series APs on IOS?
Hi, I'm looking into adding either WLSE or Wireless Controllers to manage our AP's, and have been reading through the posts here and the CCO guides to get a handle on the Controllers because I have not worked with them. In the Controller Configuratio...
Planning to add a 5GHz 802.11A module to the existing AIR-AP1231G-A-K9. Among other issues - optimal configuration, separation of networks, etc. - I have one pure hardware question:What is the optimal antenna for a small office - no concrete walls or...
Switch Configuration:Do you trunk the port going to the AP?AP Configurations:Do you have to broadcast the voice (SSID) for the 7920 phone to authenticate?Do you have to broadcast the voice (SSID) in order for the phone to layer 2 roam?We're having pr...
I have a lab of 40 macintosh ibooks running OS/9 with the airport client. We recently replaced the Apple Airports with AP-350s running IOS 12.2(JA). Now, here is the problem. Ibooks running OSX work fine. the OS9's do not appear to be trying to find ...
I have a 1200 AP configured for RADIUS authentication on Microsoft IAS server but I am experiencing a problem getting clients authenticated. (Association is working fine.)The 1200 is connected to the IAS Server via an 837 router (no switch involved) ...
