Wireless

I have a 871w router up and running with dhcp on the router for vlan 1 assigning 10.1.5 addresses to cabled clients. I also have the nating working correctly for the outside interface and VPN working correctly as well. I can't get dhcp working on the...

Access Point Memory Exhaustion from ARP Attackshttp://www.cisco.com/en/US/products/products_security_advisory09186a00805e465b.shtmlblock arp attackthis problem is correct ? (below)interface Dot11Radio0 l2-filter bridge-group-acl bridge-group 1 input-...

Dear all;I have a AIR-AP1121G basestation. Recently upgraded to software version 12.3(7)JA2. Now it's reporting it has a 11B radio and hence the wireless interface is down and won't come up. See:bhap01#sh int dot11Radio 0Dot11Radio0 is reset, line pr...

I have the base station above, got it from a friend but without a power supply. I've looked inside, and board revision is A0. I have though found an alternative power supply, but have to run it on 6V. But it's specified for 1.25A.Anyway, I've got hug...

Hi,we want to use authorized ARP on an AZR in a PWLAN environment. This isn't an issue for DHCP clients since authorized arp for dhcp is around for a while.But we also support clients with static IPs (ip mobile arp + nat). I know there is a NAT accou...

hi alli have a 1300 series AP/BR.part no:AIR-BR1310G-E-K9-R (ETSI)my external antenna is "AIR-ANT24120" 12dbi.Bcoz of some TRA issues i'm forced to use 5.725-5850.From TRA i got the instruction that, if you put 12 dbi or 13.5 dbi antenna the maximum ...

Hi every budy,This is my first message in this forum,I hope you can help me to fix my BR problem. my Aironet 1310 runing now with c1310-k9w7-tar.12.3(2)JA2 and it's restart by itself(for me no problem with restarting but the problem it's return to RO...

AIR-BR1310G-A-K9-R, this device incorporates two RP-TNC connectors for external antenna.has it an integrated antenna too, like the AIR-BR1310G-A-K9?

I'm getting ready to deploy some 7920's and want to make sure I've got some decent security. What I'd like to do is combine mac address security with a userid/password unique to the phone. (or I could live with a common one for all phones but I don't...

Folks, I am using Leap and want to use CKIP as my intel based cards give me the option, what do i need to change in my access point settings to make it happen, I am wep manadatory right now.

HelloIf I connect my access point (1130) to a switch trunk port (because I need different VLANs on different SSIDs) how can I define on which VLAN the APs IP address is?Must it be the native VLAN? If so, where do I have to define it?ThanksThomas

I need pointers on how to implement proper secure bridge (point to multipoint or point-to-point) Can I use radius/tacacs to authenticate non-root bridges using their mac-address ?

We are currently implementing a full SWAN Architecture in our Organisation.As part of our business we have around 150 small ADSL sites running off Cisco 837 Routers.What I would like to know; if we replace these routers with 877 Wireless/Routers, how...