Hey Community! I'm excited to share something we've been working on that I think will really resonate with many of you managing wireless networks today. We just released the Cisco State of Wireless Report 2026, based on insights from over 6,000 wirel...
Forum Posts
Before migrating to Meraki switch (MS120) and access points (MR36), the PC which acts as Time and Attendance Server (IP- 192.168.2.250) can ping the Biometric device (192.168.2.10). They are in the same VLAN.After replacing the switch and AP, said bi...
I have my SSID "Secured-Company" setup with Enterprise using my RADIUS server. I have NPS setup with the following:Connection Request PolicyNAS Port Type = Wireless - IEEE 802.11 OR Wireless OtherNetwork PolicyNAS Port Type = Wireless - IEEE 802.11 O...
Hi everyone:I have a problem with two Cisco AIR AP's ... I have configured already eight of them (in lightweight mode), but those two send me the next error, right now.ap: %Error opening tftp://255.255.255.255/ap3g2-k9w7-tar.default (connection timed...
Hi, I have tired to add C9120AXI-E to WLC 17.6.4. Everything goes at it should but after downloading an image from WLC and reloading AP stuck in boot loop. verify signature failed for /bootpart/part2/ramfs_data_cisco.cpio.lzma [*07/28/2023 09:37:...
Model : C9800 WLAN : WPA2/802.1X Mode : Local Software : 17.3.6 Hi, The WLC session timeout setting is 1800 seconds, and during the client reauthentication phase The message 'CO_CLIENT_DELETE_REASON_KEY_XCHNG_TIMEOUT' is generated. We added the AAA A...
Alright I'm at my wits end. I need some help configuring a basic WLC setup but from distribution switch 1 to access switch 1 where the WLC makes two hops to get to the Lightweight access point it is supposed to manage. My issue is that I CAN ping the...
Dear All, I'm currently facing an issue with one AP in our customer's site, one AP has the following warning with specific ssid, whereas the rest of the AP do not have such issue, i have ran the radius test in the portal, but all of them has passed t...
Hi Team, I am trying to download the Cisco Catalyst Wireless App on my android phone (Android Version 12). However, the Google Play Store suggests the following and doesn’t allow me to install the app: “This app isn’t available for your device becaus...
Hello,I am using a WLC 9800 and I recently replaced my Aironet 2702's with Aironet 3802's. With the 2702's we had no issues and little downtime. However, since replacing them with 3802's, we're having a problem where randomly during the day, all of o...
Hello,By a mistake I've downloaded and installed newest Cupertino 17.09.04 firmware on Cisco AP C9115AXE-ENow there is no capwap commands to add this AP to my WLC.I need to "downgrade" it to Lightweight firmware. I have correct firmware (ap1g7-k9w8-t...
Hello everyone,what is the CLI command to enabled the "Admin Status" for an AP on 9800 WLC?Thanks,
Hi Team,We purchase 9130 AXE access points however we have not ordered external antenna. Just want to know if 9130 AXE still work without external antenna like ANT9101=, C-ANT9102=, and C-ANT9103= or not.If yes what will be disadvantage is there g...
We are using Cisco WLC Model 3504 all the access points are having 8.5.105.0 version installed and they are joined to WLC. However One LWAPP with version 12.4 is not able to join to WLC. All the network configurations are accurate. Now I wanted to do...
Hello,does the 9130 acts like a supplicant out of the box?We have a secured network and MAB is really a pain and kind of useless security wise.So ideally I want to use the MIC to give the AP network access, is this possible?Regards
Hi Everyone, I was hoping someone could help me with the configuration of Cisco Aironet 1562e Wireless Bridge. I have three cisco Aironet 1562e in which I would like to setup in three separate buildings. Each building will have a Cisco Cat 9300 and t...
