Wireless

I know its not supported but has anyone got the two working? i have 340's using eap and wep that work fine with laptops but give the following error when using the phone."Station [x.x.x.x]0013196ea942 Failed Reassociation, status "Can Not Support All...

Hi,I recently upgraded the IOS on all my 1200s to the new c1200-k9w7-tar.123-2.JA2. I did one to test and it appeared to be ok, but now I am seeing the following problems.1. When the AP reboots, SSH enables itself.2. NTP does not seem to work3. On my...

Is it possible to put AIR-AP1231G in repeater mode between two AIR-BR1310G (one is root and the other is non-root)? Or how to put third poin (repeater) between two AIR-BR1310G one is root and the other is non-root)?Best Regards,Jovan.

Since I did an upgrade from 122-13.JA4 to 123-2.JA2we have problems with locally generated udp broadcast in the wl-environment. The clients associate without any problems with leap and has absolutely no problems with unicast traffic. But locally broa...

my problem is that Laptop disjoint from domain if they are not used for a week or so and the only way to rejoin it to connect it to the wired NW and then to the wireless i have RADIUS server authentication MAC with EAP key management WPA with TKIP Th...

I'm configuring FSR in my WLAN and I think I have it right, I'm just a little confused about some of the log messages I'm seeing.All of my AP's and MN's are registered with the WLSM.I have my AP's configured to use both WPA and CCKM for key-managemen...

helloi'm using BBSM5.3. I can't make print billing. however. i configured the printer and i made room mapping.i installed most patches. but nothing in the printer.any comments?thanks

hello, just want to know if there's a way to have the LEAP authentication to occur first before windows logon in windows xp? I had this working last year when I was still testing the old PC Card (11b and the ACU) but it doesnt work with 11g anymore.t...

Right now I have my PEAP Session Timeout set for 120 minutes on the ACS. It is my understandingthat this is the length of time the client credentials are stored in the WDS cache. So during this time the client should never have to talk to the ACS for...

Why my client re-authenticates EVERY exactly 30 sec?I'm using Linksys clients with EAP-TLS, Cisco 1230 as AP and Microsoft IAS 2003 for Radius.

I was working with a 1200 AP running IOS and I did a write erase and reloaded it so I could start anew. Now the AP does not boot up and is looking for a config file to TFTP. If I need to upload a file, what information does it need to have?

I can not find a version of the ACU softwar for the new CB21AG cards. The software available is the ACAU, which does not have any of the site survey tools. Are the site survey tools available in another package?

I have a problem with a gprs connection.I have remotes router call out for gprs to central router.These call are good but the tcp sessions are stablished are misfire. My central router is connected to them by tunnels.My dialer in remote router config...