Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
I have a 350 Access point running 12.0T software with a laptop running ACU 5.05 and most up to date drivers. I am getting problems when I am setting up vlans that correspond to ssid. The native vlan appears to work all the time, however when I change...
Which radius servers are supported by Cisco Wireless LEAP? I used Cisco ACS which worked fine, but I was wondering whether I can use Microsoft's Radius Server (Internet Authentication Server).thanks,-serdar
Had a recent (this morning actually) event that was odd. One of our Cisco 340 bridges went "dead" sometime over the weekend. Upon looking at the bridge one LED was red (BAD) and another was amber (CAUTION). I rebooted (power cycled) the bridge and...
Greetings,Thanks in advance for any and all help you may provide.I am hoping to provide wireless connectivity to a long, fairly narrow building...essentially open space for a few hundred feet. (Building is longer than it is wide...and is 200-300 feet...
Hello there,I provide support to end users at the IBM Toronto Lab Software. We use Aironet 340 and 350 cards. I just noticed that the users cannot connect from one laptop to another using wireless cards. Pinging returns host unrechable. The machines...
Several messages on this site point to peole using EAP on a Windows 2000 client and authenticating against an IAS server. I am running an Aironet 350 AP and trying to setup my Windows 2000 clients to use EAP only and authenticate against a Windows 2...
Resolved! SNMP management on AP350
I have configured SNMP, it is enabled and the RO community is set. But from the management machine, I try to send "gets" or "snmpwalk" to the AP350 and it doesn't respond.Does anyone know what could be the problem?
I have a requirement to replace Intermec root access points with Cisco equipment. Im wondering if it's possible to use the existing Intermec access points (2102) as workgroup bridges while using Cisco 1200's as root access points? Does anyone have ex...
A Wireless Bridge Root can be associated to a Access Point No-Root ?
WIth AP1200 dual radio config 802.11a and 802.11b is it possible to turn one of the radios completely off.Thank you
Bridge can at the same time work like Bridge (Root) and Point Access (Root) ? A Bridge (Root) can be associate to a Point Access (No-Root) ?
In the power setup for the Cisco Aironet Access Points 350, it shows how power is to be supplied to the 350. My question is - why is the ethernet connection from the power injector to the switch (without inline power) needed? I think I understand ...
Hello,I have few pre-Cisco acquisition Aironet (Model #AP4822B) bridges. Are current PC and PCI cards going to function with these access points? If not, where can I get older cards that will function?Thanks,David
Has anybody gotten Apple Airports client using version 2.0 or greater software to work AP 350s configured for LEAP and Dyn WEP as well as a DHCP server.The Mac software I am using is 10.2 or 9.2.2. I can get the client to request a DHCP if I make ec...
Which event must I change in order to get the AP350 to report a configuration change to a remote syslog server? Thanks.
