Wireless

This forum does say getting started, so don't bash me too much on my ignorance.I am looking to find out exactly what I need to setup a LEAP infrastructure. (this will be just a lab test environment).I have a 1200 AP and both Windows 2000 and Windows ...

How much bandwidth does a single AP WDS domain consume to send RM data to a WLSE? I have a large WAN with slow speed links and a Cisco rep said that it would take 1Meg! Find that hard to believe. What's the actual number?Thanks!

I'm trying to use a SJphone on my desktop [and PDA],behind a PIX 515. I'm getting an error message that says "NAT/Firewall:blocked". How do I configure the PIX and/or my PC and PDA to allow me to use the SJphone. Thanks.

Hello-First off, please forgive the lack of knowledge in this post...This is pretty much my first experience with anything Cisco-related.I had a Cisco 1200 AP v12.2(13)JA4 and a Cisco BR500E v8.80 dropped off in front of me with instructions to set t...

Hello,Here is the problem. I am applying a startup config to new AP1200 from the DHCP server configured to get the config template from WLSE. The startup config only has the parameters to make the AP discoverable on the network (CDP, SNMP, Telnet/SSH...

I'm trying to get some guidance on what equipment to buy in order integrate a wireless network into my current home LAN. Current setup includes a router, 8 port switch, 2 PCs, 1 Win2k Adv Server (that can be used for anything including CA if necessar...

Hello, we have a WLAN with 25 Cisco ap's. We use only a static wep and need to strengthen our security.We have:Cisco 350 and 1200 ap'sCisco ACS 3.0 radius serverA lot of different client cards, most of then running XP sp1/sp2We want to configure the ...

Hi,whenever i try to associate WUSB54G linksys network adapter to ap1200, i obtain the following message,MAC Address IP address Device Name Parent State 000f.660f.ce99 0.0.0.0 ap1200-Rptr - the device is identified as a repeater and not as a client!!...

hi! i have installed two aironet 1300 bridges about a distance of 10 meters for a test using external antennas.i have measured the throughput without any security-options enabled between two laptops across the link running netio or ftp.the throughput...

We want to use a token server in a WLAN environment where users connect themselfes to internet or intranet resources. We would like to use RSA tokens.Question: Are there any limitations concerning the authentication protocol like LEAP, PEAP, a.s.o.?I...

Good day!Here's my problem: I have an air-cb20a series pcmcia card... yes, the 5ghz thing. Fact: I live in italy and the standards say this frequency is way too high.Is there a way (firmware patch or something) to set a lower frequency?Thanks

I am setting up a wireless network at home that will be integrated with my current LAN architecture. See the attached diagram for details, but essentially I want to place a wireless access point inside of a secure LAN and allow only specified users w...

Will IOS 12.3(2)JA support MAC Authentication on the 1310?Corey

I have an AP 1100, and want to enable so encryption on the transmission. In the past I have used MAC address authentication, and want to augment the security. (Understanding that authentication and encryption security isn't the same thing)With this, ...