Wireless

I am looking to set up a AP1100 access point and want to use the Radius authentication package that is part of Windows, does the AP authentcation package work with it?

Does anybody know any good debug commands to monitor traffic/performance on an AP? A group in my department just purchased a few wireless cameras and we want to see how the addition of these cameras will affect the overall performance on wireless.Tha...

Hi,I would like to attach a pair of 12 dBi high omni antenna to an access point for indoor coverage. Has anyone has done the similar design? I would like to use the most powerful antenna to cover 20th floors. My customer can only afford to purchase 2...

I have several accecc points 1220 connecting to thesame 3550 switch. I am able to connect fine the signal is good, however my phones give a clicking noise when they receive or make calls. I was hoping if any one has any suggestions. Thanks Dennis

I have an AP1210 IOS 12.2(15)JA. I had everything working in my lab. Now it's at a remote site and I receive the following log message even though I have an SSID configured under the dot11radio0 interface.%DOT11-4-NO_SSID: Interface Dot11Radio0, no S...

I'm looking for a good explanation regarding the following:XXXXX Aironet AP 1210 Radio-B Port Dot11Radio0 Packet Error is in Degraded state (29%) P4 Degraded 15:26:59 06/07/2004 I've set up the faults, but haven't came across and good explanation how...

If I configure CCKM, will CCKM dynamically change the session keys or does that still have to be done in the RADIUS server?

If I configure CCKM on my AP, does that trigger 802.11i RSN Information Elements (IEs) to be transmitted with the AP beacons and probe respose frames? If CCKM or WPA is not enabled, I'm assuming that the beacons would look like the original 802.11 st...

When configuring a VLAN using LEAP authentication and the "encryption mode wep mandatory" command, what encryption type is being used - 64(40) bit WEP or 129(104) bit WEP?If you use "encryption mode ciphers tkip", are you using 64-bit or 128-bit WEP?

I have two Cisco WLAN adapters, CB21AG and PI21AG. I would like to setup a 802.11g (2.4Ghz 54Mbps) (in adhoc mode) connection between two computers. However the connection is always established at 11Mbps. (Computers are close ( 3-4 ft), and only the ...

I have 8 1200's connected a local network, they are using a radius server for 802.1x. The client machines are suppose to get a DHCP address from the DHCP server on the same network as the AP's (that have static addresses), so far I have only once bee...

I am running PEAP with Cisco AP 1200. It has happened more than one time that the AP is not responding to new association although there are active assoications in the AP. I have to restart to AP in order for it to work again. Does anybody encounter ...

hi i'm using 1230 B access point and i'd like to set a starting page (home page) if anyone using my wireless network. so if an user start his browser, the first page displayed in the browser should be the one i set, like if you use starbucks wlan,the...

I recently configured WEP between 2 wireless bridges. They seem to be communicating fine, but how can I verify that the WEP encryption is working, like utilizing any Debug commands. Also, if I use 4 WEP keys, how does that impede the performance of t...