Wireless

The question I have today concerns using 2 antennas with a Cisco 1200. We have a customer that was using Proxim MP11s along with Proxim 600s to provide Internet in an apartment complex with 560 units and 8 APs. They were getting poor performance so t...

Think i am right in saying cisco don't currently ship an 802.11g based wireless bridge.Anyone know of any plans of ciscos for the introduction of such a device (lots of other manufacturers do them). i have a customer who needs>6M, doesn't want to use...

I have a root AP with 6 dbi wall mount patch anntena , I still have uncovered area and I can only use repeater , this is an outdoor area (planes RAMP)that looks like a soccer field with 280 m distance from the root AP to the edge . Can I use repeater...

Hi, While a wired backbone might be a better solution, due to limitations I am looking at setting up 350's as repeaters with a maximum of 3 links. Does anyone have any experience in how well, if at all, a 350 will operate as a repeater through the fl...

I have an access point, 350 w/ Firmware 12.02T1. I am having problems with it rebooting several times a day due to an error saying the memory is full. The error in syslog is FATAL): Rebooting System due to Out Of Memory Anyone know what is going on w...

I would like to do an omni coverage wireless connection between the radius of 1KM.I'm planning to use Cisco aironet bridge with an omni directional AIR-ANT24210.I will set the aironet bridge to act as an A.P so my client notebook will get the wireles...

The management VLAN for our APs is 196. Is there anything wrong with setting up the BVI interface as follows:?interface BVI1 no ip address no ip route-cache!interface BVI196 ip address 130.39.196.48 255.255.252.0 no ip route-cache!ip default-gateway ...

Does anyone know if there is any bulk install method for Aironet Wireless Client? --for example, with VPN client, we can preconfigure the .ini and .pcf files and distribute it with the ext file -- Is there anything like that can be done with the Airo...

Does WLSE 2.5 support 802.11a radio scans for channel stats and everything? I have a WLSE 2.5 and an 802.11b/a network, and it seems to be not seeing any of the .a radios. If not does anyone know when it will. Thanks.

I have a AP on my inside private network. I set up port fowarding on RTR to forward internet traffic to my AP which works fine, for telnet sessions. Problem is, when I try to view WWW traffic, I'm blocked somewhere. I've tried everything, I'm beginni...

We have a problem with a Cisco AP350 Access Point. It has stopped responding to all network and radio traffic.The lights on the top are all on (Ethernet = Solid Red, Association = Solid Green, Radio = Solid Amber). Of the lights by the network socket...

Hi,any idea to monitor the cpu load on a 350 bridge? (snmp, telnet, ..)RegardsAlex

Hi all,Did somebody had connected a Palm Tungsten C on AP350 Aironet ? i have some difficulties, there is no connection at all. The Palm didn't see AP (even with Open Mode with no WEP key...)With an avaya card, i have done an ad-hoc connection, but i...

I am trying to figure out how we can determine how long our Aironet 350 bridges have been up. I have the date and time set in the System Log to show the exact system time and date beside events.Is there some other way to show the system up time since...