Wireless

I would like to know if freeradius implementation version 0.8-2 supports LEAP. If yes, does anybody know of any documents to configure this on freeradius?Thaks

Greetings,I was wondering if anyone had some ideas for configuring additional security on a 7200 synchronous serial interface other than access-lists when dialing in with a modem. I would like to know if its possible to be asked for a username and pa...

Under investigating the wireless architecture for large hospital, but I don¡¦t have much knowledge about medical environments. Can anyone give some suggestion or provide information about anything should be specially taken care in this critical case....

I have installed 4 BR350 bridges at a customer site. All works well except for two of the bridges. These bridges keep going down every 5 to 10 miniutes with an event in the log "Lost Authentication with Parent" on the parent bridge I get a message th...

I have created a vlan comprised of the switch ports that attach a wireless access point to the Ethernet net. Laptops, (most of them using an Aironet 350 NIC) can get a DHCP address from the server but Symbol RF units cannot. I have temporarily resolv...

Hi all,I took a 1220 that was running Vxworks and upgraded to IOS last night. The upgrade went fine, however afterwards I wasn't able to authenticate to our IAS server using PEAP with MD5. I did an erase start and tried everything from scratch (also ...

Building A (the root building) currently has an AP, building B has a WGB, building C is under construction. Can I replace the AP in building A with a BR and buy a BR for building C and expect it all to work?

Does Cisco have a case study on MMDS ? I'm particulary interested in services of video (CATV channels), voice and data running on a fixed wireless infrastructure in 2.5-2.7 GHz spectrum.thanks

I'm trying to find out if there will be any hardware or software incompatibilities with intergrating these devices. Also is there any documetation available to support this claim. Thnx. Newbie here.

Our network includes Cisco Aironet 340 series wireless bridges (in access point mode) and Cisco Aironet 340 series access points.Recently we purchased some Dell Latitude C400 systems with the built-in TrueMobile 1150 Series Mini PC Cards. The firmwar...

Please excuse a newbie on radiowaves, antenna, dBi and stuff like that. Is there a "simple" way to calculate the range (in feet or meters) for a antenna and are there any tables for how much a wall dampens that range ?For example: To me it seems like...

Hiis there a way to recover from a corrupt IOS Image after upgrade von 12.0.8 to 12.0.11 on a 1230?I get the following and need to recover or send the image again into flash.---cut---Loading "flash:/c1200-k9w7-mx.122-11.JA/c1200-k9w7-mx.122-11.JA"......

Hello all, I have a troublesome PCM350 PC card that can not associate with any AP's. All troubleshooting steps followed. Is there a way to set the card to factory defaults. Or does anyone have any other idea before this hits the graveyard.

how many non-root bridges are supported by one root-bridge (point to multi-point)?1) root-bridge have ant-2506 omni antenna2) non-root brigdes or work group bridges(ant-1949 yagi) are in the ant-2506 omni antenna's coverage.3) the number of associate...