Wireless

I have an open TAC case but was wondering if anybody else was seeing this problem. I have 150+ Cisco access-points being managed by WLSE 1.3.1. It’s a mix of 340, 350 & 1200 type hardware and running 12.00 code.First it takes between a hour to two ho...

Hi,I have a 1200 AP with 5GHz module and AIR-CB0a client adapter in demo.This all works fine (except coverage is not that good). But what I see is that when I walk arround and enter a zone with only 802.11b AP I loose my connection! So the card does ...

I am looking at implementing a WLAN across a campus on a 4-class C VLAN with an initial load of approximately 500 users to a maximum of 800 using AP 1200s. Does anyone know of the broadcast traffic that occurs? The only broadcasts that I can think of...

Only way to get wireless devices to see the default gateway is to enable BOOTP/DHCP. If access point is set to static IP then wireless devices can see rest of LAN except for default gateway. What is not configured correctly?

I would appreciate help configuring a WLAN using 3 340AP's:I intend to use one 340AP as the Root/Access Point.I have not been able to successfully configure the two remaing 340's as CLIENTS. I have association with the client 340's, and using a cross...

Only way to get wireless devices to see the default gateway is to enable BOOTP/DHCP. If access point is set to static IP then wireless devices can see rest of LAN except for default gateway. What is not configured correctly?

Hello Guys,i configure Portocol filter like on this Page , but still get a connection to my AP when i connect as a user,please helphttp://www.cisco.com/en/US/products/hw/wireless/ps430/products_configuration_guide_chapter09186a00800e02cf.html#1028373...

Hello there,All my WAPs are running Cisco 350 Series AP 12.02T1. I set up a couple of VLANs (one for the users and the other one for the WAPs). All my Cisco Aironet clients worked fine; however, my 802.1x clients could not associate.I need specific s...

I have an AIR-LMC350 that I can't seem to get working. I also have a couple AIR-PCM350's and they work fine and the docs seem to indicate that they all use the same driver. I've tried this card in laptops running XP, 2000 and Linux.One thing I wonder...

Hi,has anyone succeeded in changing the security settings (Authentication Types: Open, Shared, Network-EAP) for SSID ID [0] using WLSE?I know it can be done for SSIDs [1] and above, but how about [0]?I am running WLSE v1.3.1, and Cisco 1200 AP on 12....

We are using RADIUS to do MAC authentication as well as set the SSID / VLAN for the client. However, our Aironet 1220 (12.02T1) does not seem to be using the Session-Timeout attribute.Cisco references using RADIUS attribute 27 (Session-Timeout) to li...

Hi,Many times i tried now to reset the Access point to its default parameters.I fallowed precisely the users manually But it doesn't work. The Accesspointist still set by the last changes, because the SSID is alway the same and not the standard SSIDS...

Does anyone know of a free utility for 'real-time' monitoring of Wireless signal. I am looking for something to load on my notebook, that I can walk around with and display in real time a coverage map of the RF coverage area from the bridge.. I am us...