Wireless

helloif i have 2 separated wired LAN . the distance between the two LANs is about 200m. normally we use optic fiber to connect the two LANs. can we use 2 AP 350 (one in each LAN) to connect the 2 LANs.i'm not sure it's possible because i think if we ...

I am a bit confused reading through the relese notes on this subject. I am using 11.21 code and setting up my "NON Root" Bridge as a LEAP client.This works fine. I do not have any WEP keys entered in either device. If I do enter a WEP key, I can only...

Can someone explain or reference documentation that explains in detail what happens when APs have the same channel overlap? I realize there will be collisions, but how determental is it to performance if part of the coverage area overlaps on the same...

I believe that 802.11e has yet to ratify the QoS standards for WLAN. Is there any info on the QoS Roadmap/Development of Cisco Aironet Products. Will QoS be available (proprietary or standards based) on the entire Aironet Series or will this be limit...

Is there a https or secure shell telnet access to the BR350 from the network? DoD will require all http, SNMP, and telnet access to a bridge to be disabled. The only way to configure a bridge would be via local serial port and hyperterminal. Are ther...

Dear All,I have some strange kind of problem with Aironet 340 Series Bridge.When I start it, it gives the error " Unable to determine Radio Type "Also it does not give the SSID and other DSS related parameters, instead it gives a new option of FH (Fr...

Hi all, We are trying to set up a WLAN asigning the client IP addresses via DHCP. The subnet of the WLAN users will be different that the one of the AP. The DHCP server is a 7200 router. Our problem is the users get an IP address on the subnet of the...

My Aironet 350 Workgroup bridge is connected to wired LAN through omnidirectional setup. Some of the computers on the LAN are able to pickup DHCP address while others are not. At times those who did pick up DHCP addresses will drop, making it very di...

Hello, Can anyone tell me if i can use a AP350 (captive antennas) as a bridge ???i tried upgrading firmware but still just works as AP....

helloif i have an AP350 without fixed antenna.can i use the antenna provided by PCI wireless cards? has it the same power?generally, if we use 2 antenna is it better than using one ?

I have 3 points A,B & C. From A to B is 7km & B to C is 1km. There is a mast in both A & B and thay can see each other, also B & C can see each other . I'm going to install 3 aironet 350 wireless bridge and choose these antennas : 21dbi solid dish fo...

I'm using a Lucent WavePoint-II access point (WEP enabled).It works well with lucent and 3com lan adapters but it fails withthe CISCO 350 adapter... The CISCO adapter can associate to the adaptor but it seems it can't transmit or receive anypackets. ...

Hi,As far as i know, you can turn off the beacon signals of an AP to prevent sniffers from knowing of the presence of an AP. What if the user is connect to AP1 and that his signal is weak, will it auto change to AP2 (stronger signal) when both AP is ...

Hi, I'm working with CiscoSecure ACS 3.0 for Windows manage aironet access points. There seems to be a problem when I activate Network Access Restrictions. Basic Authentication works fine and I am able to apply restrictions to all AAA Clients. Howeve...

Hi,I refer to the cisco aironet 1200 specifications. What do you mean by DHCP support under the automatic configuration? Does it mean that it supports DHCP request and forwards to the DHCP server? Or it dishes out it's own IP address and acts as a mi...