Wireless

Hi,What is the chipset used for the aironet 342/352 aironet client cards? Someone told me it's the Prism II chipset but I thought all along Cisco is using it's own chipset?Can someone clarify this?

Since RC4-128 is not FIPS complaint, I need to add 3DES VPN on top of LEAP. So far only Cisco 3000 and XP worked well. Any advise is welcome.Thanks,Audie

If my ap's ssid is 1234,broadcast is on,my client ssid is 2345,can I associate to my app

Are the two antenna connections designated as incoming and outgoing or are they bi-directional? If they are bi-directional, can different antenna types be connected to each port? Ex. one point-to-point antenna and one point-to-multipoint antenna for ...

Hi I would like to know if anyone used arerial splitters to improve coverage and whether or not it was sucessful. i.e. 2 aerials back to the same access point.Would this configuration be supported by Cisco?Ian Vickery

Hi all,I have seen people doing site surveys with the ACU in different ways especially when doing the site survey at more then one data rate. Some just look at the signal to noise ratio in dB levels, while others look at the packet success rate (perc...

Not using WEP or LEAP all Win32 and Win CE clients work. LEAP was just turned on and WinCE clients will not associate. Using CLS you see an association after login with WLM and then it is lost. I have used multiple combinations with and without the d...

We are going to enable leap at our stores but we have 2 issues:1) Once LEAP is active then you can only dial in after someone has authenticated to the server, we checked the box "No Network Connection Unless User is Logged In" box under LEAP Settings...

Is there a way to use the wireless signal obtained by the access point (in this case a repeater) and route it to a wired network or the ethernet port on the access point itself? I know there is a routing option under "Services" on the Access Point bu...

I would like the best method to configure my AAA on my individual AP via the http: can I configure via other methodRegardsMcNaz

The American Society for Testing and Materials International (ASTM) Subcommittee E 17.51, which deals with Vehicle Roadside Communication, recently approved a new DSRC standard at 5.9 GHz that particularly relates to communication between roadside de...

Hello, I'm searching for the possibility of connecting two router over GSM/GPRS network. On our central site we can connect the router to the GSN node of the operator. But on the remote side what can we connect a GPRS modem to the router to go throug...

I am running version 11.21 on the AP 340 and 4.25.30/8.2.3 on the 350 client (win 2K). When looking at the adapter I see the IP address but cannot ping the IP address of the AP ethernet interface. The client is associated with AP340When looking at th...

Hello,I have two questions about Aironet 1200:- Are the filtering functionnalities the same as on Aironet 350? Does it allow to do filtering on destination MAC/IP address?- Cisco Aironet 1200 is able to both communicate with 802.11 a and .11 b termin...

I have 3 points X, Y and Z. Y is the cental point equiped with one bridge 340 and 12dbi omni antenna, the others sites have one bridge 340 and Yagi 13.5 dbi antennas each of them. They are configured with 11 Mbps speed. From X to Y is 1,8 kms and Y t...