Wireless

I noticed in the log of one of our access points the there are several Radio Error : Holdoff timeouts and also several Queue full discards. Why are we getting these and what can be causing them. Thanks.

I've got a brand new client install that associates with the AP but will not receive a DHCP address. Any help would be appreciated?

We have installed test Aironet 350 AP's and cards to try to get a reasonable level of security for wireless (LEAP, MIC, WEP key rotation, etc.). We have LEAP enabled and working, and have the AP's configured to require network EAP. The one troubling ...

I have been able to get Xircom wireless adapters to use the draft 8 standard when using LEAP authentication. However, they cannot use draft 10 due to the outdated firmware available for them. I wonder if it might be possible to flash them with airone...

Wanted to let everyone know about the new wireless LAN certification called CWNA. More info at www.cwne.com

Hi, I have a customer outside the USA and want to set up a wireless internet service within 20-30miles radius of a city. What is the best way to do this? thanksmuratmkose@nurtel.com

Is there a configuration option available for a Cisco AP-350 which allows for access to the ethernet port when the AP is in Repeater/Non-Root mode?I need to provide a host client w/ an ethernet tap off an Access Point.

Hi.I look for information about a dual mode phone(if it exists), combining VoIP(over WLAN) and GSM/CDMA.Regards.Baruch.

Can the Cisco Aeronet 340 Access Point using the 802.11b protocol be upgraded to 802.11a via some type of firmware or any other upgrade?thankshpfeil

Hi,anyone can suggest how to secure the web access? Can we control the web access by ip addresses instead of just username/password configured in the AP itself? I have thought of using ACLs to control but how about users from the same subnet as the A...

Does 802.1x alone support WEP key management and dynamic key distribution or is it just a user authentication mechanism only?

Hi,For 4 months I have been trying to use the Cisco Aironet 350 in a W2K notebook on a wireless network provided by the Linksys router BEFW11P1. The problem I am facing is after not using the computer for 10/20 minutes or not accessing the network fo...

I'm trying to figure out which devices can associate with a workgroup bridge? Any help would be appreciated.

I have tried to configure an ip address ina A WGB-350, but the IPSU returns this message (THE DEVICE DOES NOT ANSWER). I try with a cross cable in a non-network computer and with a direct cable in a network computer, but the device doesn´t answered. ...

I think ive finally decided on what Radio to use for the ISP Services. I Have several (20+) Cellsites and am planning on using Sector Antennas at each cell for the Clients to connect to. I have a couple quick questions before I start ordering tomorro...