Wireless

Hi there - I'm a beginner to Cisco products, but have bought an 1830 series AP and am trying to convert it to autonomous mode.   When I plug it in using the POE injector (with 'To Switch' going to my router, and to AP going to the Access Point), it b...

Hi We want to bridge an ap to wireless router. The topology is like this:Internet ---------- wireless router(ip 10.0.0.1) .................ap(10.0.1.1)-------computersThe wireless router is non-cisco device. The ap is connected to wireless router thr...

Hi All, I'm trying to find out where Ingress and Egress QoS policing is applied for client QoS in a setup with a Foreign and an Anchor controller.My configuration has identical ingress and egress QoS applied to both controllers and the QoS is policin...

Hi all, I'm trying to find a definitive answer as to whether the Meraki MR and MS series support DTLS when using RADIUS with Cisco ISE  I don't believe this is available currently, it's certainly not configurable on Meraki switches and APs we have in...

HI  Everyone, I have a issue that is a autonomous ap2702 cannot broadcast ssid. attached is show tech info,please help to reslove it . thanks~

Hi All, I have Cisco Wireless Infrastructure as below :Wireless Controller : Cisco WLC 5520Cisco WLC Version : 8.10.130.0Cisco AP : AIR-AP2802I-F-K9Cisco AP Mode : Local SwitchingI found strange issue. when client connect to 802.11ac using 5ghz the s...

My company has a number of large sites with numerous wiring cabinets and, often multiple switches in a stack configuration.During a recent equipment refresh discussion  the question came up as to whether to place all AP connections on one switch or t...

Hi, as the title suggest, I would like to change the channel width wider for 5ghzChange several setting in the GUI, and it shows 40MHz (2ch, attached), strangely, using wifi scanner, all channels width are still 20MHz (only 1 ch) Run wifi scanner in ...

How to disable/bypass automated sign-in popup browser for Android devices on a virtual WLC

I am trying to setup my 9130AXE for wireless survey work.  In the past it was easy to setup the AP for autonomous mode and you were done.  Now with the 9130 I believe there are multiple steps.  I was able to convert my 9130 to run as a embedded wirel...

Hi all I have recently installed a 2602 Standalone AP, However I can only see the N radio config on it, I cant see anyting about a,b or g ? how do I switch these on ? cheers