Wireless

There is no ssid signal after AP left the first WLC and join to the second WLS. The two vwlc are same model and should have the same configuration. and have the same ap group. Any suggestions? Thank you

I just set up a Cisco 5508 WLC and a 3702 AP. The AP is in flexconnect mode. Both the link to the WLC and AP are trunks. Both are using VLAN 255 as their managment ip. Facing the AP I used "switchport trunk native vlan 255", and am able to reach it o...

I'm installing a few WAPs in very difficult to reach locations. Does anyone have any recommendations on a remote serial console device I can connect to the serial port on the WAP that I can run an extra cat6 cable to at the time of install? I'd rathe...

Dears,I have problem with AIR-AP1852I-I-K9 it was working from 2 days, today i have if flush (RED), i have connected form console i have found the below and no user name or password appear  r no heartbeat fo r 180s[*01/31/2021 07:58:38.6089] watchdog...

is there a way to add dynamic timestamp to the file name in the "transfer upload filename" command?

I have a Cisco AIR-A1832i-B-K9.I was intended to reset the AP to factory default, however accidently it resulted in  clearing the AP’s internal storage, including all configuration file. I think it also removed any regulatory domain provisioning made...

Hi, i have a setup with 1542AP's which i want to use to bridge two sites together. First Ap is ME and configured as RAP, the second as MAP ( Mesh ). Everything works fine, i can reach the AP over the Mesh link and i can reach a switch behind the MAP....

Hi,I am not sure how many of you have noticed active role switchover issues in 9800-CL HA SSO deployment, in my case I have 2 x 9800-CL in same ESXi host, Gig 2 interface is connected to vSwitch1 which is in trunking and promiscuous mode accept, Gig ...

Hello,  Any toughts on how to resolve this issue? Clients that connect to ssid via cisco ap's in a Controller environment are seen as rogue ap's:Rogue client: 76:28:b3:98:25:c8 is detected by 1 APs Rogue Client Bssid: f0:c4:2f:9f:22:bb, State: Alert,...

Morning, I am trialing a 9120axi at home with the 17.4.1 embedded WLC, all going well untill this moring, one laptop connects but cannot even ping the AP, let alone get any exernal connectivty.  All other devices are fine. Its like the client is diab...